Usage of lithium niobate in nonlinear optics is seriously hampered by optical damage, in particular, where high intensity is needed. Doping with magnesium can improve its resistance against optical damage. However, since a rather large dopant concentration is required (more than MgO) and since the distribution coefficient is unfavorable, it is difficult to grow crystals of high optical quality. The authors show that by doping with zirconium, one can obtain at the same time a higher resistance against optical damage, a lower doping threshold (only ), a distribution coefficient near 1.0, and a low coercive field that is only one-third of that of congruent . These properties suggest that zirconium-doped lithium niobate is an excellent choice for nonlinear optical applications.
Lithium niobate on insulator (LNOI), regarded as an important candidate platform for optical integration due to its excellent nonlinear, electro-optic, and other physical properties, has become a research hotspot. A light source, as an essential component for an integrated optical system, is urgently needed. In this Letter, we reported the realization of 1550 nm band on-chip LNOI microlasers based on erbium-doped LNOI ring cavities with loaded quality factors higher than 1 million at , which were fabricated by using electron beam lithography and inductively coupled plasma reactive ion etching processes. These microlasers demonstrated a low pump threshold of and stable performance under the pump of a 980 nm band continuous laser. Comb-like laser spectra spanning from 1510 to 1580 nm were observed in a high pump power regime, which lays the foundation of the realization of pulsed laser and frequency combs on a rare-earth ion-doped LNOI platform. This Letter effectively promotes the development of on-chip integrated active LNOI devices.
Integrated optical systems based on lithium niobate on insulator (LNOI) have attracted the interest of researchers. Recently, erbium-doped LNOI lasers have been realized. However, the reported lasers have a relatively lower conversion efficiency and only operate in the 1550 nm band. In this paper, we demonstrate an LNOI laser operating in the 1060 nm band based on a high Q factor ytterbium-doped LNOI microdisk cavity. The threshold and the conversion efficiency of the laser are 21.19 µW and 1.36%, respectively. To our knowledge, the conversion efficiency is the highest among the reported rare-earth-doped LNOI lasers. This research extends the operating band of LNOI lasers and shows the potential in realizing high-power LNOI lasers.
Holographic display has attracted widespread interest because of its ability to show the complete information of the object and bring people an unprecedented sense of presence. The absence of ideal recording materials has hampered the realization of their commercial applications. Here we report that the response time of a bismuth and magnesium co-doped lithium niobate (LN:Bi,Mg) crystal is shortened to 7.2 ms and a sensitivity as high as 646 cm/J. The crystal was used to demonstrate a real-time holographic display with a refresh rate of 60 Hz, as that of the popular high-definition television. Moreover, the first-principles calculations indicate that the electron mobility while Bi occupying Nb-site is significantly greater than that in Li-site, which directly induces the fast response of LN:Bi,Mg crystals when the concentration of Mg is above its doping threshold.
The UV photorefraction of Zr-doped lithium niobate (LN:Zr) was investigated. The experimental results show that LN:Zr crystals have high resistance against photorefraction in the UV region as well as in the visible range and can withstand a UV light intensity of above . According to the fitting results of erasing curves with UV and green light, a two-center -defect model was suggested. Our results indicate that LN:Zr is an excellent candidate for optical damage resistance from the UV to the visible spectrum.