This paper details the thermal design and the mechanical assessment procedures for an additively manufactured AlSi10Mg heat pipe, incorporating lattice structures as a wick for the cooling of a satellite power unit’s electronics. To optimize thermal performance, various lattice structures were experimentally investigated, focusing on properties, such as capillary rise, permeability, and heat removal capabilities. The best-performing lattice structure was further analyzed for its static and fatigue properties. A fatigue life model, comprising the experimental data on the lattice and SN diagrams for the bulk material obtained from propagation law, is presented. A sample representative of the heat pipe was designed and experimentally tested to validate the predictive capability of the fatigue life model and to assess the structural integrity of the heat pipe against the loading conditions experienced during a space launch. The heat pipe design demonstrated the ability to remove 24 W at 0 $$^\circ$$ inclination, a near-isothermal functioning at 18 W up to an inclination of 15 $$^\circ$$ angle, corresponding to a 34 mm height counter-gravity. The component demonstrated the capability to withstand the stresses resulting from nine repetitions of the space launch, confirming the model’s predicting capability. Graphical
Heat pipe (HP) performance depends on several interacting physical phenomena, such as phase change and liquid transport within the wick. The latter is strongly affected by the permeability of the porous material, whose accurate evaluation is essential for a reliable prediction of the heat transfer capability. This work investigates the permeability of an additively manufactured aluminum wick by comparing two experimental and two numerical methods, using acetone and ethanol as working fluids. In the first experimental approach, the analytical capillary rise curve was fitted to data obtained through infrared thermography and by monitoring the fluid level decrease in an input reservoir. In the second, the mass flow rate through the samples was directly measured under an imposed pressure difference. Numerical simulations were performed using the Finite Volume Method in OpenFOAM and the Lattice Boltzmann Method in Palabos on computational domains reconstructed from microtomographic scans of a real wick. The permeability values, determined through the Darcy–Forchheimer formulation, were then used to estimate the maximum heat transport capability based on the capillary limit model for representative HP geometries. The results show that all four methods provide consistent permeability estimates, with deviations below in the porosity range relevant to real HPs.
25 September 2025 in Fatigue & Fracture of Engineering Materials & Structures
This paper presents a methodology for monitoring fatigue damage in Triply Periodic Minimal Surface (TPMS) lattice structures using the Direct Current Potential Drop (DCPD) technique. The aim of the paper is to validate an experimental setup capable of interrupting fatigue tests at the early propagation phase, before a crack propagation through the entire wall thickness, which is considered as the operational failure condition for TPMS‐based heat exchangers. An in‐house developed LabVIEW program, to account for the effect of temperature variations, is described. The validation of the proposed methodology is supported by analyzing the fracture surfaces of specimens whose tests were interrupted using the technique. The DCPD method is also employed to gain insights into the stages of fatigue life—nucleation and propagation. The results of the DCPD are compared with common methods of fatigue test monitoring—that is, axial stiffness drop, highlighting the superior capabilities of the DCPD.