At a 1550 nm wavelength, the optical sensitivity of conventional indium gallium arsenide (InGaAs)-based avalanche photodiodes (APDs) is restricted by their high excess noise, hindering their performance in long-range free-space optical communication links. Al0.85Ga0.15As0.56Sb0.44 (AlGaAsSb), lattice-matched to indium phosphide (InP) substrates, has a much lower excess noise factor than InP, the conventional avalanche material. In this work, we evaluated the performance of optical APD-TIA receivers utilizing InGaAs/AlGaAsSb APDs through simulations and experiments. Simulations confirmed their optimum gain is much higher than conventional APDs. InGaAs/AlGaAsSb APD dies and transimpedance amplifier (TIA) chips were integrated, yielding four optical receivers for experimental evaluation. At 2.5 Gb/s and BER = 10−9, these receivers operated at a high optimal gain of 56 (as predicted in simulations) and produced a mean sensitivity of −38.5 dBm, with the best sensitivity at −39.2 dBm. These sensitivity values are at least 2.7 (or, in the best case, 3.4) dB better than those of typical commercial receivers with InGaAs APDs. This work quantifies the significant performance improvement that InGaAs/AlGaAsSb APDs provide to long-range free-space optical communication links.
To realise high-speed free-space optical communication links in harsh space environments, it is crucial to consider the link’s operating wavelength, the performance of the optical receiver, and the radiation hardness of the avalanche photodiode (APD)—optical detectors in the optical receivers. In this work, we experimentally evaluated the radiation hardness of 2.5 Gb/s receivers based on InGaAs/AlGaAsSb APDs integrated with Ommic CGY2102UH/C2 transimpedance amplifiers. Proton energy (62 MeV) and fluence (up to 3.8 × 1010 p/cm2) representative of space environments were used to irradiate multiple receivers, ensuring rigour. After irradiation, the receivers maintained their avalanche gain and photocurrent, while exhibiting bandwidths exceeding 1.5 GHz. Despite a slight increase in APD’s dark current at high reverse bias, there was no degradation of the receiver’s bit error rate. At 2.5 Gb/s data rate and 1550 nm wavelength, the irradiated receivers achieved a bit error rate of 10−9 with an average optical power of −38.2 dBm, outperforming selected commercial receivers by ~3 dB. Since the displacement damage dose induced by the proton radiation levels used in this work are representative of those in Low Earth, Geostationary and Global Positioning System orbits, we demonstrated that InGaAs/AlGaAsSb APDs have sufficient radiation hardness to be employed as optical detectors of high-speed optical links in harsh space environments.