The advent of fifth-generation (5G) systems and their mechanics have introduced an unconventional frequency spectrum of high bandwidth with most falling under the millimeter wave (mmWave) spectrum. The benefit of adopting these bands of the frequency spectrum is two-fold. First, most of these bands appear to be unutilized and they are free, thus suggesting the absence of interference from other technologies. Second, the availability of a larger bandwidth offers higher data rates for all users, as there are higher numbers of users who are connected in a small geographical area, which is also stated as the Internet of Things (IoT). Nevertheless, high-frequency band poses several challenges in terms of coverage area limitations, signal attenuation, path and penetration losses, as well as scattering. Additionally, mmWave signal bands are susceptible to blockage from buildings and other structures, particularly in higher-density urban areas. Identifying the channel performance at a given frequency is indeed necessary to optimize communication efficiency between the transmitter and receiver. Therefore, this paper investigated the potential ability of mmWave path loss models, such as floating intercept (FI) and close-in (CI), based on real measurements gathered from urban microcell outdoor environments at 38 GHz conducted at the Universiti Teknologi Malaysia (UTM), Kuala Lumpur campus. The measurement data were obtained by using a narrow band mmWave channel sounder equipped with a steerable direction horn antenna. It investigated the potential of the network for outdoor scenarios of line-of-sight (LOS) and non-line-of-sight (NLOS) with both schemes of co- (vertical-vertical) and cross (vertical-horizontal) polarization. The parameters were selected to reflect the performance and the variances with other schemes, such as average users cell throughput, throughput of users that are at cell-edges, fairness index, and spectral efficiency. The outcomes were examined for various antenna configurations as well as at different channel bandwidths to prove the enhancement of overall network performance. This work showed that the CI path loss model predicted greater network performance for the LOS condition, and also estimated significant outcomes for the NLOS environment. The outputs proved that the FI path loss model, particularly for V-V antenna polarization, gave system simulation results that were unsuitable for the NLOS scenario.

Millimeter wave technology will be dominating the fifth-generation networks due to the clear advantage of higher frequency bands and hence wider spectrum. In this paper, the indoor radio wave propagation at 28 GHz is studied by developing an efficient three-dimensional ray tracing (ETRT) method. The simulation software based on the ETRT model has been verified by measurement data. The received signal strength indication and path loss have shown significant agreement between simulation and measurement. Compared with the conventional shooting bouncing ray tracing method, the proposed ETRT method has better agreement with measurement data.

To facilitate connectivity to the internet, the easiest way to establish communication infrastructure in areas affected by natural disaster and in remote locations with intermittent cellular services and/or lack of Wi-Fi coverage is to deploy an end-to-end connection over Mobile Ad-hoc Networks (MANETs). However, the potentials of MANETs are yet to be fully realized as existing MANETs routing protocols still suffer some major technical drawback in the areas of mobility, link quality, and battery constraint of mobile nodes between the overlay connections. To address these problems, a routing scheme named Mobility, Residual energy and Link quality Aware Multipath (MRLAM) is proposed for routing in MANETs. The proposed scheme makes routing decisions by determining the optimal route with energy efficient nodes to maintain the stability, reliability, and lifetime of the network over a sustained period of time. The MRLAM scheme uses a Q-Learning algorithm for the selection of optimal intermediate nodes based on the available status of energy level, mobility, and link quality parameters, and then provides positive and negative reward values accordingly. The proposed routing scheme reduces energy cost by 33% and 23%, end to end delay by 15% and 10%, packet loss ratio by 30.76% and 24.59%, and convergence time by 16.49% and 11.34% approximately, compared with other well-known routing schemes such as Multipath Optimized Link State Routing protocol (MP-OLSR) and MP-OLSRv2, respectively. Overall, the acquired results indicate that the proposed MRLAM routing scheme significantly improves the overall performance of the network.

As the enterprise of the “Internet of Things” is rapidly gaining widespread acceptance, sensors are being deployed in an unrestrained manner around the world to make efficient use of this new technological evolution. A recent survey has shown that sensor deployments over the past decade have increased significantly and has predicted an upsurge in the future growth rate. In health-care services, for instance, sensors are used as a key technology to enable Internet of Things oriented health-care monitoring systems. In this paper, we have proposed a two-stage fundamental approach to facilitate the implementation of such a system. In the first stage, sensors promptly gather together the particle measurements of an android application. Then, in the second stage, the collected data are sent over a Femto-LTE network following a new scheduling technique. The proposed scheduling strategy is used to send the data according to the application’s priority. The efficiency of the proposed technique is demonstrated by comparing it with that of well-known algorithms, namely, proportional fairness and exponential proportional fairness.

It has been widely speculated that the performance of the next generation based wireless network should meet a transmission speed on the order of 1000 times more than the current cellular communication systems. The frequency bands above 6 GHz have received significant attention lately as a prospective band for next generation 5G systems. The propagation characteristics for 5G networks need to be fully understood for the 5G system design. This paper presents the channel propagation characteristics for a 5G system in line of sight (LOS) and non-LOS (NLOS) scenarios. The diffraction loss (DL) and frequency drop (FD) are investigated based on collected measurement data. Indoor measurement results obtained using a high-resolution channel sounder equipped with directional horn antennas at 3.5 GHz and 28 GHz as a comparative study of the two bands below and above 6 GHz. The parameters for path loss using different path loss models of single and multi-frequencies have been estimated. The excess delay, root mean square (RMS) delay spread and the power delay profile of received paths are analyzed. The results of the path loss models show that the path loss exponent (PLE) in this indoor environment is less than the free space path loss exponent for LOS scenario at both frequencies. Moreover, the PLE is not frequency dependent. The 3GPP path loss models for single and multi-frequency in LOS scenarios have good performance in terms of PLE that is as reliable as the physically-based models. Based on the proposed models, the diffraction loss at 28 GHz is approximately twice the diffraction loss at 3.5 GHz. The findings of the power delay profile and RMS delay spread indicate that these parameters are comparable for frequency bands below and above 6 GHz.