• Premise of the study: Melissopalynology, the identification of bee‐collected pollen, provides insight into the flowers exploited by foraging bees. Information provided by melissopalynology could guide floral enrichment efforts aimed at supporting pollinators, but it has rarely been used because traditional methods of pollen identification are laborious and require expert knowledge. We approach melissopalynology in a novel way, employing a molecular method to study the pollen foraging of honey bees (Apis mellifera) in a landscape dominated by field crops, and compare these results to those obtained by microscopic melissopalynology.• Methods: Pollen was collected from honey bee colonies in Madison County, Ohio, USA, during a two‐week period in midspring and identified using microscopic methods and ITS2 metabarcoding.• Results: Metabarcoding identified 19 plant families and exhibited sensitivity for identifying the taxa present in large and diverse pollen samples relative to microscopy, which identified eight families. The bulk of pollen collected by honey bees was from trees (Sapindaceae, Oleaceae, and Rosaceae), although dandelion (Taraxacum officinale) and mustard (Brassicaceae) pollen were also abundant.• Discussion: For quantitative analysis of pollen, using both metabarcoding and microscopic identification is superior to either individual method. For qualitative analysis, ITS2 metabarcoding is superior, providing heightened sensitivity and genus‐level resolution.
Beekeepers providing pollination services for California almond orchards have reported observing dead or malformed brood during and immediately after almond bloom—effects that they attribute to pesticide exposure. The objective of this study was to test commonly used insecticides and fungicides during almond bloom on honey bee larval development in a laboratory bioassay. In vitro rearing of worker honey bee larvae was performed to test the effect of three insecticides (chlorantraniliprole, diflubenzuron, and methoxyfenozide) and three fungicides (propiconazole, iprodione, and a mixture of boscalid-pyraclostrobin), applied alone or in insecticide-fungicide combinations, on larval development. Young worker larvae were fed diets contaminated with active ingredients at concentration ratios simulating a tank-mix at the maximum label rate. Overall, larvae receiving insecticide and insecticide-fungicide combinations were less likely to survive to adulthood when compared to the control or fungicide-only treatments. The insecticide chlorantraniliprole increased larval mortality when combined with the fungicides propiconazole or iprodione, but not alone; the chlorantraniliprole-propiconazole combination was also found to be highly toxic to adult workers treated topically. Diflubenzuron generally increased larval mortality, but no synergistic effect was observed when combined with fungicides. Neither methoxyfenozide nor any methoxyfenozide-fungicide combination increased mortality. Exposure to insecticides applied during almond bloom has the potential to harm honey bees and this effect may, in certain instances, be more damaging when insecticides are applied in combination with fungicides.
Premise of the study: Difficulties inherent in microscopic pollen identification have resulted in limited implementation for large‐scale studies. Metabarcoding, a relatively novel approach, could make pollen analysis less onerous; however, improved understanding of the quantitative capacity of various plant metabarcode regions and primer sets is needed to ensure that such applications are accurate and precise.Methods and Results: We applied metabarcoding, targeting the ITS2, matK, and rbcL loci, to characterize six samples of pollen collected by honey bees, Apis mellifera. Additionally, samples were analyzed by light microscopy. We found significant rank‐based associations between the relative abundance of pollen types within our samples as inferred by the two methods.Conclusions: Our findings suggest metabarcoding data from plastid loci, as opposed to the ribosomal locus, are more reliable for quantitative characterization of pollen assemblages. Furthermore, multilocus metabarcoding of pollen may be more reliable than single‐locus analyses, underscoring the need for discovering novel barcodes and barcode combinations optimized for molecular palynology.
The health of honey bee colonies cannot be understood apart from the landscapes in which they live. Urban and agricultural developments are two of the most dramatic and widespread forms of human land use, but their respective effects on honey bees remain poorly understood. Here, we evaluate the relative attractiveness of urban and agricultural land use to honey bees by conducting a foraging choice test. Our study was conducted in the summer and fall, capturing a key portion of the honey bee foraging season that includes both the shift from summer- to fall-blooming flora and the critical period of pre-winter food accumulation. Colonies located at an apiary on the border of urban and agricultural landscapes were allowed to forage freely, and we observed their spatial and taxonomic foraging patterns using a combination of dance language analysis and pollen identification. We found a consistent spatial bias in favor of the agricultural landscape over the urban, a pattern that was corroborated by the prevalence in pollen samples of adventitious taxa common in the agricultural landscape. The strongest bias toward the agricultural environment occurred late in the foraging season, when goldenrod became the principal floral resource. We conclude that, in our study region, the primary honey bee foraging resources are more abundant in agricultural than in urban landscapes, a pattern that is especially marked at the end of the foraging season as colonies prepare to overwinter. Urban beekeepers in this region should, therefore, consider supplemental feeding when summer-blooming flora begin to decline.