Although the dosage of cationic flocculants used for water treatment is well known to increase in the presence of natural organic matter (NOM), the underlying reasons for this increase are not properly understood. Herein, we studied the flocculation behavior of polystyrene latex (PSL) particles in the presence and absence of polyacrylic acid (PAA5K) as an NOM analogue using an end-over-end rotation apparatus for standardized flow mixing. In the absence of PAA5K, the initial rate of cationic flocculant (PAM5M)-induced flocculation was enhanced, as reflected by the size of flocculant in solution. Additionally, flocculation experiments were performed in the presence of 0.5 mg/L PAA5K for five concentrations of PAM5M and two ionic strengths, and the increase of the initial rate of PAM5M-induced flocculation was suppressed by PAA5K immediately after mixing, with the most pronounced suppression obtained at a PAM5M concentration similar to PAA5K. Based on the above insights and the results of viscosity measurements, the inhibitory effect of PAA on flocculation was ascribed to (1) the reduction of PAM charge and the concomitant shrinkage via electrostatic association with PAA and (2) the termination of polycation adsorption on PSL caused by polyion complex formation when the charge ratio of PAM:PAA is close to unity.
1 January 2014 in Solvent Extraction Research and Development, Japan
Simulated electroless nickel plating liquid wastes have been processed by using an emulsion flow extractor of a counter current type with a special focus on the influence of dilution of the liquid wastes on the extraction performance. The emulsion flow extractor provides efficient liquid–liquid extraction without the need for additional stirring or shaking. The solvent used in the present study was a Shellsol D70 solution containing LIX84-I as the extractant for nickel and PC88A as an accelerating agent. As a result, it was found that increasing the degree of dilution with water resulted in an improvement in nickel extractability obtained from the emulsion flow experiments with a maximum value of 96% as well as those obtained from batch experiments. Droplet sizes at the lower and the upper parts of the emulsion phases, estimated by using high-speed microscope, were 214 ± 36 µm and 415 ± 110 µm, respectively.
28 February 2015 in Journal of Radioanalytical and Nuclear Chemistry
Asian soybean rust (ASR) caused by Phakopsora pachyrhizi , an obligate biotrophic fungal pathogen, is the most devastating soybean production disease worldwide. Currently, timely fungicide application is the only means to control ASR in the field. We investigated cellulose nanofiber (CNF) application on ASR disease management. CNF-treated leaves showed reduced lesion number after P. pachyrhizi inoculation compared to control leaves, indicating that covering soybean leaves with CNF confers P. pachyrhizi resistance. We also demonstrated that formation of P. pachyrhizi pre-infection structures including germ-tubes and appressoria, and also gene expression related to these formations, such as chitin synthases ( CHSs ), were significantly suppressed in CNF-treated soybean leaves compared to control leaves. Moreover, contact angle measurement revealed that CNF converts soybean leaf surface properties from hydrophobic to hydrophilic. These results suggest that CNF can change soybean leaf surface hydrophobicity, conferring resistance against P. pachyrhizi , based on the reduced expression of CHSs , as well as reduced formation of pre-infection structures. This is the first study to investigate CNF application to control field disease.