This paper presents a comprehensive analysis of the current-stress optimization and soft-switching operation of the isolated bidirectional dual active bridge (DAB) dc-dc converter with the unified triple-phase-shift (UTPS) control. On this basis, the current-stress-optimized modulation scheme is proposed for DAB, which leads to the minimum current stress with the required transmission power and voltage conversion ratio in the whole load range. Moreover, the full soft-switching operation is achieved for the converter simultaneously. Distinct from the previous modulation schemes, the proposed optimized modulation scheme is deduced from a unified analysis of TPS where all effective switching modes are investigated. A novel algorithm based on the Karush-Kuhn-Tucker (KKT) conditions is originally proposed to derive closed-form solutions for the global optimal control parameters. This paper also presents a typical closed-loop control strategy for DAB with TPS control and detailed descriptions about the closed-loop operation. A laboratory prototype is applied, and the experimental results validate that the current-stress optimization and efficiency improvement are realized by applying the optimized modulation scheme. The experimental results also verify the effectiveness of the closed-loop control strategy for DAB with TPS control.
11 June 2020 in IEEE Journal of Emerging and Selected Topics in Power Electronics
Metallized film capacitor (MFC) is one of the key components in power electronic converters, accounting for a large proportion of failures. However, the time-varying external stress in long-term mission profile and time-varying internal stress due to the degradation of MFC are not well described by the conventional reliability evaluation method, which leads to a large deviation between the evaluation results and the engineering practices. Therefore, an improved reliability evaluation method considering time-varying stress mission profile and aging process for MFC is proposed. Firstly, this paper analyzes the influence of harmonics and provides a more accurate lifetime model under constant stress condition, compared with the conventional method. Secondly, the subsection integral accumulated damage model is proposed to transform the long-term time-varying stress mission profile to the short-term ideal constant stress condition, solving the reliability evaluation under time-varying external stress condition. And then, an improved aging model is proposed to describe the non-linear variation of equivalent series resistance (ESR) and internal temperature rise due to the degradation process of MFC. Furthermore, Monte Carlo simulation is applied to analyze the difference of individual capacitor, obtaining lifetime distribution. Finally, a practical application example of MMC system is implemented to verify the superiority of the improved method.
23 August 2023 in IEEE Transactions on Industrial Electronics
In this article, an improved multiobjective ant colony optimization (ACO) algorithm is proposed to design the weighting factors (WFs) in the model predictive control of power converters. First, the principle of the multiobjective ACO algorithm is introduced. Then, the WF design process based on the multiobjective ACO algorithm is given in both the single-function mode and the Pareto mode. Finally, improvement measures are proposed for the multiobjective ACO algorithm to reduce the calculation and accelerate the convergence. Simulations and experiments are carried out on a parallel three-level dc–dc converter. The results show that the proposed method is faster and less-computational than the traditional ACO algorithm, and is more accurate than the particle swarm optimization algorithm. With the proposed method, higher solution diversity and smaller control error can be achieved. In addition, the proposed method can also be used for WF online tuning, which will bring more benefits when the converter parameters are mismatched.
26 December 2022 in IEEE Transactions on Power Electronics
The dual active bridge (DAB) dc-dc converter plays an important role in energy exchange between DC microgrids integrated with energy storage systems. To directly control the power flow between the adjacent DC microgrids rapidly and accurately, a dual-terminal voltage feedforward based direct power control scheme (DVF-DPC) with single-phase-shift control is proposed for the DAB dc-dc converter. The strategy makes the converter realize rapid and precise output power regulation under the following conditions, including the start-up process, load step-change, the desired output power step-change, and voltage fluctuations. An accurate discrete-time model is applied to analyze the system's dynamic characteristics, and a discrete-time small-signal model of the system is established to design the controller's parameters. In addition, a comprehensive and systematic analysis of all the possible unstable phenomena for adjacent DC microgrids is conducted based on the discrete-time model. Accordingly, the underlying mechanisms are revealed by analyzing the relationships among the state variables, the Floquet multipliers, and system parameters. Hence, the stability-oriented parameter design method is given which can provide guidance in practice. The theoretical analysis is verified in both the time domain and frequency domain. Finally, by comparing the DVF-DPC method with the traditional PI feedback control, the superiority of the proposed strategy is verified through theoretical analysis and experimental results, which demonstrates its application prospect in the field of electric energy dispatch control of the DC power supply network.
5 December 2022 in IEEE Journal of Emerging and Selected Topics in Power Electronics
Finite control set model predictive control (FCS-MPC) has been widely used in the control of power converters. However, for converters with multiple optimization objectives, the design of the weighting factors in the cost function is a tricky problem. To solve the weighting factor design problem in multiobjective FCS-MPC, a graphic weighing factor design method is proposed in this paper. Firstly, the discrete control variables are taken into the prediction model to determine the state boundaries of each control objective under all the system states. Then, the priorities and weighting factors of the control objectives are determined and designed by adjusting the intersection area of these state boundaries, so as to optimize the system performance. Finally, the operating condition feedback is introduced to realize an adaptive adjusting of the weighting factors so that the relationship of the state boundaries between different control objectives will not be affected by the change of system operating condition, and the controller robustness can be guaranteed. Analysis and experiment are carried out based on the parallel three-level DC-DC system. The results show that the proposed method can effectively solve the weighting factor design problem of multiobjective FCS-MPC. It is simple, efficient, and robust.
A primary control strategy of wireless power transfer system based on load identification method is proposed to meet the challenge related to wireless power transmission, system robustness and difficulties in primary controller because of the uncertainties of secondary side parameters. Take a Series-Series-type WPT system as an example, a method of online parameter identification based on switching operating frequency is proposed and a mathematical model about the load and the mutual inductance is established. Based on the proposed algorithm for online identification of parameters, a primary control strategy for wireless power transmission system is proposed. The output voltage can be controlled and power can be transmitted after the mutual inductance and load are recognized. Experimental results have verified the proposed online load identification method and primary strategy which has be demonstrated that the method is accurate and reliable for uncertain loads and mutual inductance. The method can be used in other type WPT systems to improve the system performance with precise control as well.