AC/DC power converter is the momentous interface of the power router, which is responsible for maintaining the DC bus voltage stability. However, under unbalanced and distorted grid voltage conditions, there are voltage ripples in the DC bus, and grid currents will also be severely distorted. Accordingly, this paper proposes an improved passivity-based direct power control (IPBDPC) strategy based on extended reactive power theory in the $\alpha \beta$ axis, which can effectively suppress DC voltage ripples and current harmonics of power converter. Meanwhile, with the proposed IPBDPC, the fundamental grid voltages and those orthogonal components are injected into the improved passivity model, so that the controller can further reduce the THD of the grid current when unbalanced and distorted grid conditions coexist. Compared with the traditional modified DPC, the IPBDPC strategy has a simple structure and strong robustness, does not require complex positive and negative sequence separation, and power compensation value calculation. Moreover, the sequence impedance model of IPBDPC is constructed based on the harmonic linearization method to verify the robustness of the control system against parameters uncertainty. The simulation and experimental results based on a three-phase three-level converter system further demonstrated the effectiveness of the proposed control strategy.
23 August 2024 in IEEE Transactions on Industrial Electronics
Grid-forming (GFM) inverters have the advantages of voltage and frequency support in weak grid. However, unlike grid-following inverters, GFM inverters present a more challenging picture during asymmetrical voltage sag. The voltage-controlled virtual synchronous generator (VVSG) is the typical control method of GFM inverter. However, the problem of large inrush, slow response speed, and negative-sequence current control need to be carefully considered. In the existing low-voltage ride-through (LVRT) control strategies, these issues cannot be decently coped with while maintaining the ability to support the grid. In this situation, system instability and deterioration of power quality may occur. To overcome these limitations, an asymmetrical LVRT control strategy is proposed. First, the positive and negative-sequence models are established and the asymmetrical instantaneous currents are calculated. Based on this, the influences of the VVSG control method on the instantaneous negative-sequence currents are analyzed, which reveals the role of negative-sequence virtual voltage amplitude, grid phase angle, and response speed. Then, the double closed-loop control based on VVSG control method is further improved. The negative-sequence virtual voltage is compensated in the outer-loop to achieve control of negative-sequence current and inrush current. A novel passivity-based control (PBC) strategy is extended into innerloop which has fast transient response and strong robustness. Furthermore, through the transient power angle stability analysis, the improvement of the transient margin is proved. Finally, simulation and experimental results verify the effectiveness of the proposed method.
9 January 2023 in IEEE Transactions on Industrial Informatics
This article proposes a double vector model predictive control (MPC) method for the $LC$ filtered three-level T-type inverter (3LT $^{2}$ I) to gain superior voltage performance, which is current sensorless and computationally efficient. In the proposed scheme, inverter voltage increment is induced in the multi-objectives cost function, and the desired voltage is derived based on the simplified discrete model, which optimizes the output voltage control performance. The prepositive prediction calculation is shifted out from the evaluation circle, and the computation is lessened simultaneously. Then, aiming to estimate the capacitor current of the simplified discrete model with voltage feedback only, the strong-tracking Kalman filter (STKF)-based observer is designed, which gets rid of the dependence on current sensors and lowers hardware cost. Furthermore, to improve the control accuracy of tracking the desired voltage, a two-layer decision algorithm based on the search tree is developed to find the optimal double vector easily, which obtains a low-complexity selection process using the univariate cost function. Finally, the simulation and experimental results are given to demonstrate the effectiveness of the theoretical analyses and the proposed method.
3 June 2024 in IEEE Journal of Emerging and Selected Topics in Power Electronics
This article proposed a generalized extended state observer (GESO)-based data-driven predictive control (DDPC) strategy with multi-vector for three-level inverters, which is thoroughly independent of system parameters while obtaining a satisfactory multi-objective control performance considering common mode voltage (CMV) reduction. In the proposed strategy, the predictive dynamic of output current is achieved by DDPC, and only the system input and output knowledge is needed. Meanwhile, due to the complex dynamics and difficulty of identifying by DDPC, the system uncertainties can still degrade the control performance if not solved. In this regard, the GESO is introduced to estimate the unknown uncertainties as a new extended state, which is further compensated in the control law, enabling a significant robust performance enhancement. Then, aiming to reduce the CMV, virtual vectors are constructed into the candidate vectors to replace the small vectors with high CMV magnitude. Moreover, three optimal vectors are selected to synthesize the reference voltage, where the current harmonic and the neutral-point imbalance are simultaneously suppressed. Finally, the validity of the proposed strategy is proved by simulation and experiments on a three-level T-type inverter.
25 May 2022 in IEEE Transactions on Industrial Electronics
In order to meet the high current quality and low leakage current requirements in high power rating photovoltaic applications, an improved carrier-based modulation (ICBM) for parallel converters is presented in this article. Different from existing methods which are based on phase-shifted pulsewidth modulation, a proper zero-sequence modulation wave is injected into the three-phase modulation waves to achieve a low total current ripple based on the root mean square value analysis of the output current ripple. Aside from this, the initial phase shift angles for the carriers in each converter are modified to minimize the excitation source of leakage current, while the quality of total output current is not affected. Furthermore, the proposed ICBM is extended to parallel multilevel converters according to the vector shift principle. By using the proposed ICBM, total current ripple reduction and leakage current attenuation in parallel converters can be achieved simultaneously. Experimental results validated the correctness and effectiveness of the proposed method.
23 April 2025 in IEEE Transactions on Industrial Electronics
Grid-forming inverters (GFMIs) suffer from inevitable performance degradation in the presence of parametric uncertainties when regulated by conventional model predictive control (MPC) in islanded operation. In this regard, a novel full-form dynamic linearization (FFDL)-based predictive control strategy is proposed to improve the voltage performance with enhanced parameter robustness for the islanded-mode GFMIs, which are purely data-driven and current sensorless. Specifically, the FFDL data model are introduced to identify the output voltage dynamic without requiring any prior knowledge of the precise mathematical model, while the cost function with multiple control targets is modified to avoid bringing extra system parameters. Therefore, the parameter sensitivity issue is effectively tackled since only the input/output data are utilized, enabling a strong robustness against the system parameter variations. Meanwhile, compared with the MPC method, the current information used to predict the output voltage is eliminated in the proposed scheme because both inductor and load currents are inherently excluded from the prediction model, which achieves current sensorless with enhanced system reliability. Moreover, to further lessen the computational burden, the cost function evaluation is simplified with only one voltage reference estimation by transforming the optimization process into a linear least square problem. Finally, comparative experimental results verify the effectiveness of the proposed strategy.