This study investigates the effect of Reynolds number on unsteady buffet characteristics of the OAT15A supercritical airfoil under transonic conditions (Ma = 0.73, AOA = 3.5°) using DDES based on the SST k-ω turbulence model coupled with the γ-Reθ transition model. Results show that, compared with fully turbulent conditions, the free-transition cases exhibit a more downstream shock position and higher lift. Under fully turbulent conditions, higher Reynolds numbers drive the shock downstream and enhance its stability. Under free-transition conditions, the shock moves downstream at low Reynolds numbers but shifts upstream at high Reynolds numbers due to changes in the transition location. During the unsteady buffet cycle at low Reynolds numbers, the lift increases as the shock moves downstream and the separation region shrinks. The lift reaches its maximum when the separation is minimal, corresponding to a quiet flow state with weak acoustic emission. As the lift decreases, a large separation region forms behind the shock, forcing the shock upstream and reducing the lift to its minimum. At high Reynolds numbers, the buffet cycle changes: the shock becomes more stable; trailing-edge vortex shedding intensifies; lift oscillation amplitude decreases; and buffet frequency increases.
Long-endurance hypersonic vehicles face the dual challenge of withstanding extreme aerodynamic heating while meeting onboard power requirements. Integrating thermoelectric generators within thermal protection systems offers a solution by converting thermal loads into electrical power. However, accurate prediction requires resolving coupled multiphysics, where three-dimensional simulations are computationally prohibitive and existing one-dimensional models lack accuracy. This study develops a quasi-two-dimensional distributed thermal network incorporating shape-factor corrections for rapid, high-fidelity prediction. Multi-objective optimization is performed to balance specific power, thermal expansion mismatch, and thermal margin. Analysis reveals fundamental trade-offs: a maximum-power design achieves 28.1 W/kg but only a 0.8% thermal margin, whereas a balanced design delivers 24.5 W/kg with a 5.1% thermal margin and significantly reduced thermal stress. Despite geometric variations, peak conversion efficiency converges to approximately 13%. This indicates that efficiency is primarily governed by material properties, while geometric optimization effectively tunes temperature and thermal strain distributions, providing guidelines for reliable system development.