Optimizing the operating temperature of lithium-ion batteries is critical for safe, reliable, and efficient cell operation. Manufacturers’ recommendations vary in this area, which is primarily determined by the cells’ chemical composition and internal structural characteristics. Most manufacturers define the maximum charging voltage level as the same or close to the same value, but there are significant differences in the lower threshold voltage. Lithium-ion cells exhibit increased internal resistance at lower state-of-charge levels, resulting in elevated heat generation during operation, with intensity proportional to the depth of discharge. However, using a too low voltage threshold causes a significant loss of usable capacity, which reduces the cell’s energy utilization. The present research aims to define and analyze the optimal value of the lower voltage threshold more precisely, considering both thermal development and usable capacity aspects. A further objective is to determine an optimal energy safety margin level that provides a suitable compromise for longer-term storage. Different 18650 and 21700 standard lithium-ion cell types were tested using various load profiles. The results show that the two cell formats have different electro-thermal behaviors. The 21700 cells show a clear increase in thermal efficiency at around 3.1 V. In contrast, the 18650 cells have a heating pattern that depends heavily on the load. This requires selecting a cutoff that adapts to the discharge rate to prevent excessive thermal stress. These findings indicate that a fixed lower threshold voltage for all cells is not ideal. Instead, we need cutoff strategies that are specific to each cell and can change dynamically. The TER-based evaluation introduced in this work provides a practical framework for defining these adaptive limits. It may improve control in battery management systems in real-world applications.
Lithium-ion batteries are widely used in modern energy storage systems; however, increasing power demand makes thermal management a critical challenge, particularly for cylindrical cells operating under high discharge conditions. This study investigates the thermal behavior of cylindrical lithium-ion cells equipped with additively manufactured polymer housings produced by fused filament fabrication (FFF). PLA, PCTG, flame-retardant PLA (FG_PLA), and ASA housings were evaluated using Samsung 50S, Molicel P42A, and Reliance RS50 cells under 1C–5C discharge rates. Surface temperatures were measured at multiple locations to assess heat transfer through the housing structures. All investigated housings reduced the measured maximum cell surface temperature compared with the housing-free configuration, particularly at high discharge rates. PLA exhibited the greatest thermal buffering effect, while PCTG showed the highest estimated conductive heat-transfer rate and a more uniform temperature evolution across the housing. ASA demonstrated stable thermal behavior, with thin housings generally showing a greater measured temperature reduction than thick configurations. In contrast, flame-retardant PLA provided the smallest temperature reduction. Wall thickness influenced the transient thermal response but did not consistently result in a greater measured temperature reduction. At elevated temperatures, partial deformation of some polymer housings was observed. The results demonstrate that FFF-manufactured polymer housings can substantially modify the transient thermal response of cylindrical lithium-ion cells, while material selection and housing geometry remain key design parameters for passive thermal management applications.