Lithium-ion batteries are widely used in modern energy storage systems; however, increasing power demand makes thermal management a critical challenge, particularly for cylindrical cells operating under high discharge conditions. This study investigates the thermal behavior of cylindrical lithium-ion cells equipped with additively manufactured polymer housings produced by fused filament fabrication (FFF). PLA, PCTG, flame-retardant PLA (FG_PLA), and ASA housings were evaluated using Samsung 50S, Molicel P42A, and Reliance RS50 cells under 1C–5C discharge rates. Surface temperatures were measured at multiple locations to assess heat transfer through the housing structures. All investigated housings reduced the measured maximum cell surface temperature compared with the housing-free configuration, particularly at high discharge rates. PLA exhibited the greatest thermal buffering effect, while PCTG showed the highest estimated conductive heat-transfer rate and a more uniform temperature evolution across the housing. ASA demonstrated stable thermal behavior, with thin housings generally showing a greater measured temperature reduction than thick configurations. In contrast, flame-retardant PLA provided the smallest temperature reduction. Wall thickness influenced the transient thermal response but did not consistently result in a greater measured temperature reduction. At elevated temperatures, partial deformation of some polymer housings was observed. The results demonstrate that FFF-manufactured polymer housings can substantially modify the transient thermal response of cylindrical lithium-ion cells, while material selection and housing geometry remain key design parameters for passive thermal management applications.
Heat-set threaded inserts provide a practical solution for reusable, load-bearing joints in FDM-printed polymer parts; however, their pull-out performance is governed not only by the insert itself, but also by the surrounding printed architecture. This study examines the pull-out behavior of heat-set M3 inserts embedded in FDM-printed PLA specimens across three wall thicknesses (1.28 mm, 1.6 mm, and 1.92 mm) and three infill patterns (adaptive cubic, cross-zag, and gyroid) using a repeatable drill-stand-based insertion fixture and a two-stage embedding protocol at 190 °C. Across 27 specimens, mean peak pull-out force ranged from 1353.6 ± 7.5 N to 1551.5 ± 20.4 N. Two-way ANOVA showed that both wall thickness and infill pattern significantly affected peak force, although the wall-thickness effect was practically modest—a 20% increase in material yielded only a 4.6% increase in mean force. Cross-zag specimens failed at significantly lower loads than adaptive cubic and gyroid, which performed comparably. Two specimens (7.4%) failed prematurely because of defective insert threads rather than the printed structure, underlining the importance of fastener quality control.