We demonstrate high-performance ultraviolet photodetectors (UV-PDs) based on lattice-matched (LM) InAlN/AlGaN heterostructure field-effect transistors (HFETs) gated by transparent ITO films. Low dark currents of 6.8 × 10−8 and 6.1 × 10−7 A/mm and high photocurrent gains over four and three orders of magnitude were obtained for the LM In0.12Al0.88N/Al0.21Ga0.79N and In0.10Al0.90N/Al0.34Ga0.66N HFETs, respectively. The negative threshold voltage shifts under illumination indicate that most of the photo-generated carriers are transported in the two-dimensional gas (2DEG) region around the InAlN/AlGaN interface. High peak responsivities of 2.2 × 104 and 5.4 × 104 A/W and large UV-to-visible rejection ratios greater than 104 and 103 were achieved for the LM In0.12Al0.88N/Al0.21Ga0.79N and In0.10Al0.90N/Al0.34Ga0.66N HFET-type UV-PDs, respectively. These improved performances with respect to other AlGaN UV-PDs around the same wavelength detection range may possibly be attributed to the greater contribution of the photogenerated electrons to the 2DEG, which results from the increase in the polarization sheet charge density at the InAlN/AlGaN interface. The LM InAlN/AlGaN heterostructures provide relatively promising candidates for realizing high-performance HFET-type UV-PDs.
We demonstrate an efficient heat transport hybrid structure by means of bonding GaN on a high thermal conductivity graphite composite (GC). The heterogeneous GaN/GC of the fine bonding interface, without air voids and cracks, is confirmed. More interestingly, GaN bonded on GC is stress-free and quite beneficial for device performance, the degradation of which is partially subject to the stress induced by the fabrication and packaging processes. Moreover, the thermal boundary conductance (TBC) across the GaN/GC interface is accurately estimated to be approximately 67 MW/m2K, based on the measured TBC between Ti and GC, in excellent agreement with the prediction using the corrected diffuse mismatch model. According to the finite element modeling results, the GaN-on-GC power transistor shows superiority and possesses greatly improved thermal performance due to the high thermal conductivity of GC and adequate TBC across the GaN/GC interface, compared to the commercially available GaN-on-SiC and GaN-on-Si transistors. Our findings highlight the potential of GC as a promising alternative heat spreading substrate candidate for thermal management applications in GaN-based next-generation high power electronics, including radio frequency amplifiers, high voltage power switches, and high breakdown voltage diodes.
6 September 2021 in IEEE Transactions on Electron Devices
Polarization-engineered Al 0.2 Ga 0.8 N channel heterostructure field-effect transistors (HFETs) with quaternary InAlGaN barrier layers have been investigated theoretically and numerically. The polarization-matched (PolM) normally-OFF InAlGaN/Al 0.2 Ga 0.8 N HFETs exhibited great breakdown characteristics, in which large breakdown voltage ( ${V}_{B}$ ) and highly efficient modulation of ${V}_{B}$ have been observed by varying the Al composition in the InAlGaN barrier. The electron drift velocity of approximately 1.1 $\times \,\,10^{{7}}$ cm/s, on par with that of the GaN channel HFETs, was achieved and become saturated in the Al 0.2 Ga 0.8 N channel of the InAlGaN/Al 0.2 Ga 0.8 N PolMHFETs when the ON-state drain bias operated in the current saturation region. Moreover, the electron saturation velocity of the InAlGaN/Al 0.2 Ga 0.8 N PolMHFETs showed a little deviation from that of an Al 0.2 Ga 0.8 N channel layer at high electric fields which was attributed to the carrier injection from the contacts neglected in the analytical model. As a result, superior RF power performance was obtained for the normally-OFF InAlGaN/Al 0.2 Ga 0.8 N PolMHFETs, according to the small- and large-signal simulation results. These findings highlight the advantages and potential of normally-OFF InAlGaN/AlGaN PolMHFETs for applications in high-frequency power electronics enabled by the alternative large ${V}_{B}$ without increasing the device dimension or Al composition in the AlGaN channel and high electron saturation velocity.
Normally-off AlGaN channel heterostructure field effect transistors (HFETs) have been proposed and investigated numerically by taking advantage of the polarization engineering perspective in III-nitrides. The utilization of polarization-matched InAlN/AlGaN heterostructures shifted the threshold voltage to approximately 1.1 V for an Al0.3Ga0.7N channel HFET. Compared to the AlGaN/GaN HFEF with a low breakdown voltage, the normally-off InAlN/AlGaN HFETs show substantially enhanced breakdown characteristics. Besides, the two-dimensional electron gas (2DEG) mobility in the InAlN/AlGaN HFETs exhibits much less reduction with the increasing temperature than that in the AlGaN/GaN HFET, according to the calculation of electron mobility dominated by alloy disorder scattering and polar optical phonon scattering. As a result, the temperature dependences of the power figures of merit based on the conduction loss consideration in terms of 2DEG mobility variation and Johnson figure of merit show superior potential for polarization-matched InAlN/AlGaN HFETs in high-power and high-frequency electronics applications particularly operating at elevated temperatures. This work provides a useful way for demonstration of normally-off AlGaN channel HFETs and is also helpful for design of future devices, which can be beneficially exploited from polarized III-nitride heterostructures.
We report on distinct light emission from two-dimensional electron gas (2DEG) at a lattice-matched (LM) In0.12Al0.88N/Al0.21Ga0.79N heterointerface. The recombination between the electrons in the 2DEG in the ground state E1 and photoexcited holes in the Al0.21Ga0.79N layer was identified. In contrast to GaN channel-based heterostructures (HSs), larger activation energy of the 2DEG-related emission from LM In0.12Al0.88N/Al0.21Ga0.79N HS was obtained to be approximately 17 meV, which enables the distinguished 2DEG photoluminescence (PL) peak to be more thermally stable. Moreover, the existence of the 2DEG accelerates the reduction of the PL lifetime of the emission from Al0.21Ga0.79N. Compared to the general 2DEG PL feature with a broad recombination band in GaN channel-based HSs, the improved emission characteristics of the 2DEG in the In0.12Al0.88N/Al0.21Ga0.79N HS were attributed to electron localization in a deep triangular potential well, large 2DEG density induced by the In0.12Al0.88N layer, and the improvement of the interfacial crystal quality due to the lattice match between In0.12Al0.88N and Al0.21Ga0.79N layers. These findings provide important insight into understanding the InAlN-based HSs and will be potentially useful to advance the electronic and photonic applications for group-III nitrides.