Since electronic devices deteriorate when used in extremely high electric fields, it is essential to explore the potential of dielectric capacitors with high energy density under medium electric fields (MEFs). In this study, a polymorphic multiscale domain construction strategy was proposed to optimize the energy storage performance (ESP) of (1−x)Bi0.5Na0.5TiO3-xCa(Ta0.5Al0.5)O3 (xCTA, x = 0, 0.05, 0.1, 0.15, 0.2) under MEFs. The symbiosis of rhombic (R) + tetragonal (T) phase polar nanoregions (PNRs) was achieved through the design of Ca2+ and (Ta5+ + Al3+)4+ doping to phase ratios. This resulted in a significant recoverable energy density (Wrec) of 5.89 J cm−3 and an efficiency (η) of 87.4% at 370 kV cm−1 for the 0.15CTA ceramic. In addition, the 0.15CTA ceramic exhibited excellent ESP stability (30 °C–200 °C and 1–200 Hz) and achieved ultra-high power density (Pd = 154 MW cm−3) and a fast discharge time (t0.9 = 54.07 ns). This work presents a promising approach to boost the ESP of ceramic capacitors under MEFs.
5 September 2025 in Journal of Materials Research and Technology
B4C-HfB2-SiC (BCHS) ceramic composites were fabricated by in situ reaction with B4C and HfSi2 mixed powders through spark plasma sintering in this work. Effects of sintering temperature and sintering additive (HfSi2) content on the density, microstructure, and mechanical properties of the BCHS specimens were studied. The BCHS composite containing 15–30 vol.% HfSi2 reached over 98% theoretical density in the temperature range of 1600–1750 °C under the pressure of 50 MPa. The Vickers hardness, fracture toughness, and room temperature flexural strength of BCHS sintered at 1650 °C with 25 vol.% HfSi2 reached a maximum value of 31.3 GPa, 5.6 MPa·m1/2, and 573.9 MPa, respectively. The flexural strength was not decreased at elevated temperatures, and the flexural strength at temperatures of 400 °C, 600 °C, and 800 °C was evaluated to be 540.7 MPa, 518.8 MPa, and 586.9 MPa, respectively. Dense B4C-HfB2-SiC composites were fabricated by the spark plasma sintering process. The introduction of HfSi2 can significantly enhance the density and mechanical properties of B4C ceramic.
A CuNiCe-O nanocomposite was fabricated on the Cu40Ni20Al10Ce26Pt3Ru1 metallic glass (MG) ribbon surface by dealloying. The influences of Ni and dealloying time on the morphology and EOR performance were analyzed. The results suggest that the catalytic activity and stability of the dealloyed MG ribbon could be significantly enhanced owing to the alloying of Ni to the Cu60Al10Ce26Pt3Ru1 MG ribbon precursor. The activated D-Cu40Ni20Al10Ce26Pt3Ru1 ribbon obtained at an etching time of 3 h had a better electrochemical ethanol oxidation reaction (EOR) performance than other dealloyed samples due to the formation of abundant active sites and the presence of defects within the CuNiCe-O composite.