The mechanical response and fracture behavior of two architected 3D-printed hardened cement paste (hcp) elements, ‘lamellar’ and ‘Bouligand’, were investigated under uniaxial compression. A lab-based X-ray microscope was used to characterize the post-fracture crack pattern. The mechanical properties and crack patterns were analyzed and compared to cast hcp. The role of materials architecture and 3D-printing-induced weak interfaces on the mechanical properties and fracture behavior are discussed. The pore architecture that inadvertently forms in the design of solid architected materials dictated the overall mechanical response and fracture behaviors in both 3D-printed architected materials. While no specific crack pattern or microcracking was observed in the cast element, lamellar architecture demonstrated a crack pattern following weak vertical interfaces. Bouligand architectures, on the other hand, exhibited a helical crack pattern with distributed interfacial microcracking aligned with the helical orientation of filaments. As a result, the bouligand architected elements showed a significant 40% increase in work-of-failure compared to cast counterparts. The enhanced energy absorption was obtained without sacrificing the strength and was attributed to higher fractured surface and microcracking, both of which follow the weak helical interfaces.
Global demand for adaptable and rapidly deployable construction solutions in offshore, coastal, and fluvial environments continues to rise, driven by pressing needs to develop energy platforms, improve coastal resilience, and support emergency response in the face of natural disasters. Increased investment in human-made coastal infrastructure, such as piers, support structures for power lines, offshore wind farms, and seawall protection systems, further underscores this trend. This study investigates the development of printable concrete mixtures for underwater environments using seawater as a replacement for freshwater, using a 3D printing syringe-based extrusion system. The effect of seawater addition and the printing medium (in air vs. underwater) was assessed via rheological and mechanical performance characterization. The results indicate rheological properties are favorable for seawater adoption by producing mixtures with higher yield stress and viscosity with the same levels of admixtures used for freshwater. Seawater-based mixtures demonstrated superior dimensional stability compared to freshwater counterparts, maintaining cross-sectional geometry, while compressive strength results showed no statistical differences between in-air and underwater samples. However, flexural strength was significantly influenced by geometry and printing medium. These findings establish critical rheological parameters for printable underwater mixtures and highlight the need for optimized curing strategies and layer bonding techniques to improve interfacial strength in underwater 3D printing applications.