The earlier planning methods of supply chains (SC) in the skeleton of the extended material requirements planning (EMRP), where the time horizon of the reverse Laplace is infinite, were not convenient to estimate the impact of the technical obsolescence of the product or technology involved, which has economic, environmental, and social consequences. Therefore, the perturbations of timing are presented until the possible obsolescence, with parallel execution of the network simulation model (NSM) to evaluate the impact of the finite lifespan on the value of the chain. The EMRP, as well as the NSM, are based on the skeleton of the material requirements planning model, where delays and their perturbations are presented transparently. Contrary to the previous studies of the net present value (NPV) in the EMRP skeleton, where the infinite horizon is assumed, the impact of shortening the horizon of activities is shown here, in order to also evaluate the risk of financing investments in the SC with a shorter lifespan of products or technology. Owing to the simultaneous appearances of the stochastic variables, the parallel execution and exchanging of data, using NSM is advised. The procedures for estimation of correction factors of the NPV and their values are given.
The study of everyday phenomena involving friction continues to maintain a high level of difficulty despite its long history. The causes of this problem lie in the different scale of the characteristics of the phenomenon, macroscopic and microscopic. Thus, very different models, valid in a narrow scope which prevents generalization, have been appearing. This survey presents the application of network simulation method to the numerical solution to the study of friction at very different scales. On the one hand, on a microscopic scale an atomic force microscope model has been studied, related to the analysis of soft surfaces at the atomic scale. Furthermore, on a macroscopic scale model related to the analysis of an industrial device, such as a brake mechanism has been studied. After presenting herein is a review of the different formulations of the friction force, the nature of the surfaces involved in the phenomenon, as well as the definition of the problems to be analyzed. The design of network models and the implementation of the initial conditions are explained. The results of the application of network models to selected problems are presented. In order to verify the reliability of the proposed models, their results are compared with the solutions obtained by other numerical methods or experimental results, one from a device developed during the preparation of this report.
The Burgers–Huxley equation is a partial differential equation which is based on the Burgers equation, involving diffusion, accumulation, drag, and species generation or sink phenomena. This equation is commonly used in fluid mechanics, air pollutant emissions, chloride diffusion in concrete, non-linear acoustics, and other areas. A general methodology is proposed in this work to solve the mentioned equation or coupled systems formed by it using the network simulation method. Additionally, the implementation of the most common possible boundary conditions in different engineering problems is indicated, including the Neumann condition that enables symmetry to be applied to the problem, reducing computation times. The method consists mainly of establishing an analogy between the variables of the differential equations and the electrical voltage at a central node. The methodology is also explained in detail, facilitating its implementation to similar engineering problems, since the equivalence, for example, between the different types of spatial and time derivatives and its correspondence with the electrical device is detailed. As an example, several cases of both the equation and a coupled system are solved by varying the boundary conditions on one side and applying symmetry on the other.