In various parts of Indonesia, particularly in coastal areas, wind energy can be used as a source of electricity, using wind turbines, whose energy depends on wind speed. Basically, the number of blades in a wind turbine affects the overall turbine performance. This research analyzes the influence of the blade number on the performance of a small-scale horizontal-axis wind turbine using experimental measurements and Computational Fluid Dynamics (CFD) simulations. The CFD simulations were conducted using ANSYS 2022 R2 software on a small-scale horizontal-axis wind turbine with variations in the number of blades, specifically three, four, and five blades, conducted at various wind speeds. It should be noted that due to the setup limitation in the experiment, only the RPM of the three-bladed turbine was measured. Other variables such as torque and power were derived from CFD simulations. The results of this research indicate that an increase in the number of turbine blades tends to result in higher power output, where the highest output obtained was 46.25 Watts. Furthermore, as the number of turbine blades increases, the turbine efficiency also tends to increase, but as wind speed increases, the efficiency decreases. This is demonstrated by the research results, where a wind turbine with five blades achieved the highest efficiency at a speed of 3 m/s, at 38.00%, while at a speed of 6 m/s, the efficiency was 34.80%. Overall, through experiments and cross-validation of CFD and QBlade version 0.963.1, the present study could confirm the significant effect of the number of blades on the power produced by a small-scale horizontal-axis wind turbine under low-speed conditions.
Indonesia has the potential to develop floating wind turbines at sea. Therefore, its movement response needs to be analyzed to ensure that the turbine works properly. This research aims to determine the floating offshore wind turbine barge’s movement response with different floater shapes to regular waves from three different directions (0°, 45°, 90°). The movement response of the floating wind turbine was analyzed using the diffraction and radiation analysis methods in Ansys Aqwa. The research results include the RAO curve for the structure in a couple of two degrees of freedom (heave-pitch) combined with 2-dimensional analyses. The motion response of the floater cube has a maximum value heave motion 0.999 m/m and pitch motion 2.228 °/m, and, the cylindrical shape has a heave motion 1.132 m/m and pitch 10.050 °/m. Lastly, the octagonal has a heave motion 1.010 m/m and pitch 2.565 °/m. The shape and volume of each model affect the response value obtained. The simulation results in this paper can provide considerations in selecting the right floater shape to be used as a wind turbine floater foundation.