Utilizing wind turbines typically involves a large-scale project with extremely huge wind turbine sizes. Because of this, the use of wind turbines in Indonesia is not yet very common and widespread among the community. Basically, a wind turbine has blades; the number of blades on a wind turbine can affect the overall performance of the turbine. Large-scale wind turbine projects usually implement tapered blades, while small-scale projects use taperless blades. Therefore, in this research, a horizontal-axis wind turbine with taperless blades will be used as the object of study to find out the optimal number of taperless blades that can achieve the best performance of a small-scale wind turbine category. The method used in this research is to design a horizontal axis wind turbine equipped with taperless blades with varying numbers of blades, namely three blades, four blades, and five blades, and then simulate the turbine's performance with wind speeds of 3 m/s to 6 m/s. The present research found that the greater the number of turbine blades tends to produce greater power. This is proven by research results, where the highest power in a small-scale horizontal axis wind turbine produces a power of 20,30 Watts in a 5-blade turbine variation for the wind speed of 6 m/s.
In various parts of Indonesia, particularly in coastal areas, wind energy can be used as a source of electricity, using wind turbines, whose energy depends on wind speed. Basically, the number of blades in a wind turbine affects the overall turbine performance. This research analyzes the influence of the blade number on the performance of a small-scale horizontal-axis wind turbine using experimental measurements and Computational Fluid Dynamics (CFD) simulations. The CFD simulations were conducted using ANSYS 2022 R2 software on a small-scale horizontal-axis wind turbine with variations in the number of blades, specifically three, four, and five blades, conducted at various wind speeds. It should be noted that due to the setup limitation in the experiment, only the RPM of the three-bladed turbine was measured. Other variables such as torque and power were derived from CFD simulations. The results of this research indicate that an increase in the number of turbine blades tends to result in higher power output, where the highest output obtained was 46.25 Watts. Furthermore, as the number of turbine blades increases, the turbine efficiency also tends to increase, but as wind speed increases, the efficiency decreases. This is demonstrated by the research results, where a wind turbine with five blades achieved the highest efficiency at a speed of 3 m/s, at 38.00%, while at a speed of 6 m/s, the efficiency was 34.80%. Overall, through experiments and cross-validation of CFD and QBlade version 0.963.1, the present study could confirm the significant effect of the number of blades on the power produced by a small-scale horizontal-axis wind turbine under low-speed conditions.