The interaction of doxorubicin (DX) with model polynucleotides poly(dG-dC)·poly(dG-dC) (polyGC), poly(dA-dT)·poly(dA-dT) (polyAT), and calf thymus DNA has been studied by several spectroscopic techniques in phosphate buffer aqueous solutions. UV–vis, circular dichroism, and fluorescence spectroscopic data confirm that intercalation is the prevailing mode of interaction, and also reveal that the interaction with AT-rich regions leads to the transfer of excitation energy to DX not previously documented in the literature. Moreover, the DX affinity for AT sites has been found to be on the same order of magnitude as that reported for GC sites.

We report on the effect of 1-pentanol loading on the phase behaviour of mixtures of CTAB/water/n-hexane at fixed mole ratios 1∶80∶47. The cosurfactant induces changes in the interfacial film curvature. By increasing the pentanol/CTAB mole ratio, the system evolves from oil-in-water to water-in-oil structures. For very large 1-pentanol loading some water is expelled from the reverse micelles resulting in a L₂plus water equilibrium (emulsification failure). In the range of compositions investigated most of the phase equilibria reveals the coexistence of liquid crystals and hexane/pentanol solutions. In these cases, we estimate the interface composition by assuming a constant 1-pentanol concentration in all the oil domains, and by tacking into account the alcohol solubility in water. In the case of single-phase sample the interfacial composition was determined by means of turbidimetric titration. The adsorption of cosurfactant at the interface of direct micelles, planar lamellae, bicontinuous microemulsions, and spherical reverse micelles follows the same adsorption isotherm (independently from the curvature of the interface). Moreover, the results obtained unambiguously show that the interface composition dictates the spontaneous curvature of interfacial film. Actually positive, null, and negative curvatures correspond to different compositions of the interfacial film. Once the influence of cosurfactant on the spontaneous curvature of the interface is understood, the appearance of the emulsification failure upon pentanol loading can be rationalised within the framework of the flexible surface model.

The metal-based deep eutectic solvent (MDES) formed by NiCl₂·6H₂O and urea in 1:3.5 molar ratio has been prepared for the first time and characterized from a structural point of view. Particular accent has been put on the role of water in the MDES formation, since the eutectic could not be obtained with the anhydrous form of the metal salt. To this end, mixtures at different water/MDES molar ratios (W) have been studied with a combined approach exploiting molecular dynamics and ab initio simulations, UV-vis and near-infra-red spectroscopies, small- and wide-angle X-ray scattering, and X-ray absorption spectroscopy measurements. In the pure MDES, a close packing of Ni²⁺ ion clusters forming oligomeric agglomerates is present thanks to the mediation of bridging chloride anions and water molecules. Conversely, urea poorly coordinates the metal ion and is mostly found in the interstitial regions among the Ni²⁺ ion oligomers. This nanostructure is disrupted upon the introduction of additional water, which enlarges the Ni-Ni distances and dilutes the system up to an aqueous solution of the MDES constituents. In the NiCl₂·6H₂O 1:3.5 MDES, the Ni²⁺ ion is coordinated on average by one chloride anion and five water molecules, while water easily saturates the metal solvation sphere to provide a hexa-aquo coordination for increasing W values. This multidisciplinary study allowed us to reconstruct the structural arrangement of the MDES and its aqueous mixtures on both short- and intermediate-scale levels, clarifying the fundamental role of water in the eutectic formation and challenging the definition at the base of these complex systems.