Different degrees of soil contamination have been generated by oil spills and leaks from storage tanks in refineries and processing facilities, as well as by the on-and-off loading of oil in different depots. In addition to the careless disposal of spent goods (engine oil) on the ground, this also causes environmental degradation of the soil. In the present study, the effect of contamination of sandy soil by gasoline under circular footing was studied. The circular footing is supported by sandy soil that has been polluted with gasoline by mixing the sand with different percent by dry weight with gasoline (10, 15, and 20%). The contaminated soil is extended to a depth of D/2 and D (where D is the footing diameter). The findings revealed that if the underlying sand is polluted with gasoline, the carrying capacity of the foundation reduces notably. The decline in bearing capacity was found to be 65.6, 59.4, and 51.3% for the sand’s percentages of contamination (10, 15, and 20%), respectively, at the depth of contamination D/2. The reduction in carrying capacity had been discovered to be 70, 78.7, and 33.1% for the depth of contamination D and for the percentages of contamination in the used sand 10, 15, and 20%. respectively. When the depth of contamination is raised from D/2 to D, the carrying capacity decreases by roughly 5–20% for the same percentage of pollution.
1 November 2025 in IOP Conference Series: Earth and Environmental Science
The idea of adding fibers or other tension-resisting materials to cohesive soils to reinforce them is gaining traction among geotechnical engineers. For many years, soil stabilization with various chemical and mechanical methods was introduced to improve the engineering characteristics. This research aims to enhance the properties of weak clay soil through the application of glass fibers (GF) at varying content levels (0.5, 1.0, 2.0, and 4.0%). Three standard tests were carried out to evaluate the treated soil: the modified Proctor test, the CBR test, and the UCS test. The results of experimental work showed that the OMC decreases with the addition of GF while the maximum dry density increases up to 1.0% GF, after which it tends to decrease. Additionally, the test results of the UCS test explained that the unconfined compressive strength increases with increasing the inclusion of GF contents. The CBR increases. reaching a maximum value at 2.0% glass fiber content, after which it begins to decrease.
This study performs a comprehensive experimental analysis of the dynamic response of geocell-reinforced sandy subgrades exposed to traffic-induced loading. A series of laboratory tests were performed using a custom-manufactured loading apparatus capable of creating monitored dynamic waveforms representative of vehicular traffic. A steel strip footing was assigned on both unreinforced and geocell-reinforced sandy beds to evaluate the implementation of the reinforcement in attenuating transmitted vertical stresses and surface settlements. The influence of key parameters, among which were load amplitude (0.5 and 1.0 tons), loading frequency (0.5, 1.0, and 2.0 Hz), and relative density of sand (30% loose and 60% medium), was systematically examined. The applied dynamic loading was based on a force-controlled sinusoidal waveform with constant amplitudes and frequencies, which corresponded to low-frequency harmonic cyclic loading in the case of traffic-induced quasi-static effects. Therefore, the experimental results indicate that geocell reinforcement reduces the transmitted vertical dynamic stress by up to 45% and reduces surface settlement by about 60% compared to unreinforced sand. However, the heightening efficiency decreases with loading frequency, the amplitude of the load, and the relative sand density. Thus, the findings are important in highlighting the capacity of geocell systems to enhance the longevity and efficiency of sand substrates when the systems are subjected to low-frequency harmonic cyclical loading conditions pertaining to traffic-induced quasi-static influences.