Poor water quality is a major contributing factor to disease in developing countries. Silver-coated ceramic pot filters (CPFs) are a relatively common form of household water treatment system (HWTS) representing an effective and sustainable technology for poor communities. Water production seems to be the major limiting factor of the CPF's lifetime and sustainability since low flow rates do not produce an adequate daily volume of treated water. This paper describes a long-term study of CPF flow rates under controlled conditions using three different water sources. The relationship between water characteristics and flow rate was assessed with the intent of identifying the principal parameters that impact CPF water production. The study concluded that turbidity seems to be the principal indicator in determining CPF lifetime in terms of quantity of treated water. There is no evidence that biological activity also contributes to premature failure of CPFs and the data did not indicate that chemical precipitation is responsible for the filter clogging. Manufacturers commonly conduct initial flow rate tests using clear water as a measure of quality assurance. However, the relationship between initial flow rate and average flow rate during the lifetime of the CPF should be further studied.
Ceramic pot filters (CPFs) are an effective means of household water treatment, but the characterization of CPF lifetimes is ongoing. This paper describes a lifetime field study in Guatemala which was made possible by a collaboration between researchers, CPF-using households, and local non-governmental organizations (NGOs). Disinfection data were collected periodically for two years using field coliform enumeration kits as were flow rate data with the assistance of NGO staff. Consumer acceptance was characterized by surveying householders in the four subject villages at the beginning and end of the study. Flow rate data showed that average CPF flow rates decreased below the recommended minimum of 1 L h−1 after 10 months of use; however, the survey results indicated that the consumers were tolerant of the lower flow rates, and it is reasonable to assume that the daily volume of treated water can be readily increased by refilling the CPFs more frequently. Of greater concern was the finding that disinfection efficacy decreased below the recommended bacterial reduction after 14 months of use because it would not be obvious to users that effectiveness had declined. Finally, the follow-up visits by the researchers and the NGO staff appeared to increase consumer acceptance of the CPFs.
Carbon farming represents a strategic approach to enhancing agricultural sustainability while reducing greenhouse gas (GHG) emissions. In Türkiye, agriculture accounted for approximately 14.9% of national GHG emissions in 2023, dominated by methane (CH4) and nitrous oxide (N2O). By increasing carbon storage in soils and vegetation, carbon farming can improve soil health, water retention, and climate resilience, thereby contributing to mitigation efforts and sustainable rural development. This study reviews and synthesizes international and national evidence on carbon farming mechanisms, practices, payment models, and adoption enablers and barriers, situating these insights within Türkiye’s agroecological and institutional context. The analysis draws on a systematic review of peer-reviewed literature, institutional reports, and policy documents published between 2015 and 2025. The findings indicate substantial mitigation potential from soil-based practices and livestock- and manure-related measures, yet limited uptake due to low awareness, capacity constraints, financial and administrative barriers, and regulatory gaps, highlighting the need for region-specific approaches. To support implementation and scaling, the study proposes a policy-oriented, regionally differentiated and digitally enabled MRV framework and an associated implementation pathway designed to reduce transaction costs, enhance farmer participation, and enable integration with emerging carbon market mechanisms.
Ceramic pot filter (CPF) technology is a relatively common means of household water treatment in developing areas, and performance characteristics of CPFs have been characterized using production CPFs, experimental CPFs fabricated in research laboratories, and ceramic disks intended to be CPF surrogates. There is evidence that CPF manufacturers do not always fire their products according to best practices and the result is incomplete combustion of the pore forming material and the creation of a carbon core in the final CPFs. Researchers seldom acknowledge the existence of potential existence of carbon cores, and at least one CPF producer has postulated that the carbon may be beneficial in terms of final water quality because of the presence of activated carbon in consumer filters marketed in the Western world. An initial step in characterizing the presence and impact of carbon cores is the characterization of those cores. An optical method which may be more viable to producers relative to off-site laboratory analysis of carbon content has been developed and verified. The use of the optical method is demonstrated via preliminary disinfection and flowrate studies, and the results of these studies indicate that the method may be of use in studying production kiln operation.