This paper describes a control algorithm based on modified enhanced phase-locked loop (MEPLL) in dynamic voltage restorer (DVR). It compensates distortions and unbalances in the supply voltage along with voltage sag/swell. Three-phase MEPLL extracts the fundamental positive-, negative-, and zero-sequence components from the distorted/unbalanced signals. Further fundamental positive-sequence components are used in the reference load voltage calculations. In addition to track the angle of the input signals similar to the conventional PLLs, the proposed algorithm (MEPLL) offers features of getting fundamental and sequential components in case of distorted or unbalanced grid voltage for all the three phases simultaneously. Optimization approach named as autonomous groups particle swarm optimization, a variant of PSO is used for the calculation of PI-controller gains. The integrated time square error is used as a cost function for optimization of an error between the reference and actual values. This approach of tuning PI gains improves the performance by eliminating the manual process. The proposed control algorithm is implemented in DVR system using MATLAB software and validated in a laboratory environment. The performance shows that the proposed control algorithm gives time effective and satisfactory solution for the unpredictable issues mentioned.
14 January 2021 in IEEE Journal of Emerging and Selected Topics in Industrial Electronics
A custom power device known as dynamic voltage restorer (DVR) has been investigated to operate a distribution system at its desired performance. The distribution system with voltage-related power quality issues in the supply side has been addressed through this article using DVR. Four different grid disturbances, such as voltage sag, swell, unbalances, and distortions, have been taken into account while testing the DVR capability. DVR has been controlled using optimized proportional and integral (PI) gains integrated with gradient adaptive variable learning rate least mean square control algorithm. Adaptiveness of variable step-size in LMS makes the control robust in case of dynamics in the system, which assures better performance. Also, the other major contribution of this article is the implementation of optimization-based self-tuning PI gains in the proposed control. The evaluation of optimizer in estimating the PI gains is presented in terms of the response of dc-link voltage DVR. The simulation work of proposed control algorithms on DVR has been done and satisfactory results are found. For the experimental validation, d-SPACE made Micro Lab Box is used as control processor, and both dynamic and steady-state results are discussed for its effectiveness.
1 January 2019 in IEEE Journal of Emerging and Selected Topics in Power Electronics
In this paper, a three phase three wire Dynamic Voltage Restorer system has been chosen with Quasi Newton (QN) Filter based control algorithm. It uses Hessian Matrix iteratively which is also named as Quasi Newton based on modified Broyden-Fletcher-Goldfarb-Shanno (MBFGS) in each phase. The main features of this algorithm are the fundamental frequency estimation, rejection of harmonics its components and tracking of peak value of voltage or current. As DVR in this application has been implemented for compensation of voltage disturbances like imbalance and distortions along with voltage sag and swell, the fundamental component of the supply voltage is essential components to design control algorithm. The QN technique using MBFGS has been used for exaction of the fundamental component from each disturbed supply voltage, which has been utilized in generating the reference load voltage. For PI regulator gains estimation, the population based optimization technique, called as Multi Verse Optimization (MVO) has been introduced in this work. The MVO optimization algorithm has adaptive coefficients which gives the benefits of smoothly maximizing the possibility of wormholes in the universe and increases the accuracy of the local search. The validation of control algorithm with optimization techniques based PI tuning for DVR has been done using MATLAB software and real time implementation.
20 May 2020 in IET Generation, Transmission & Distribution
This study discusses a control algorithm for dynamic voltage restorer (DVR) based on sliding mode observer (SMO) with an optimisation‐based proportional integrator (PI) tuning to compensate the voltage related power quality problems. In this work, a three‐phase VSC‐based topology of DVR is selected with a self‐supported capacitor. This DVR configuration using the proposed control algorithm has been used for mitigation of unbalance, sag, and swells in the supply voltage. The estimation of grid parameters in undesirable situations based on the exosystemic model are the advantages proposed control. New nature‐inspired optimisation algorithm named as Harris hawks optimiser (HHO) has been applied to obtain the PI gains in the control algorithm to eliminate the time required for the tuning process. The main advantage of HHO is the avoidance of local minima and exploration and exploitation features of the algorithm. DVR system with a combination of SMO‐based control algorithm along with HHO optimised PI controllers have been developed in MATLAB/Simulink and tested for above said voltage‐based disturbances mitigation in the supply voltage.
Renewable penetration, particularly the increasing deployment of PV by residential customers, organizations, and utilities, is leading to the rapid evolution of the power grid. However, the power system’s architectural changes affect the quality of supply and give rise to power quality issues such as harmonics, fluctuations, disturbances, etc., at the point of common coupling (PCC). Therefore, in this work, a power network was modeled to study the impact of PV systems on PCC. At first, a detailed review is presented for on-grid PV systems with different inverter topologies, control techniques, sources of harmonic generation, and their mitigation strategies. After that, several use cases considering various sources of harmonics in a network with on-grid PV are modeled and simulated using MATLAB/Simulink. In-depth research was performed in this work to examine the many variables that affect harmonics, such as solar radiation levels, controller tuning, and load changes. Results with a real-time simulation platform (OPAL-RT) are presented in this paper for several use cases. Lastly, comprehensive discussions are presented from the acquired offline and real-time simulation results.
22 July 2021 in International Journal of Emerging Electric Power Systems
This paper presents stability enhancement of a test system that is connected with a Wind Farm (WF) by using Power System Stabilizer (PSS) for Synchronous Generator (SG) and Power Oscillation Damper (POD) for Static Var Compensator (SVC). This paper also proposes a coordination mechanism for the controller to effectively damp out the oscillations and make the power system more stable by considering the uncertainties. The uncertainty is considered as wind speed variation and wind power penetration and different locations. The Particle Swarm Optimization (PSO) is used to overcome the controller parameter tuning drawbacks and controller coordination. The SG rotor speed deviation is selected as an objective function with various constraints for PSO. The transient stability analysis is carried out by considering large disturbance that is a three-phase fault. The nonlinear dynamic simulation results are obtained by integrating WF and SG replacement with the same rating WF. Evaluation and analysis are performed for various cases and different combination of without and with controllers. From the simulation results, it is noticed that oscillations in the system are minimized, and stability is enhanced at the maximum level. It also observed that the capability of SG and DFIG under three-phase fault is intensified by using PSO for optimized coordinated controller parameters. The robustness and effectiveness of the proposed approaches are evaluated on the IEEE-11 bus test system.