23 January 2018 in IEEE Transactions on Power Electronics
Most of two-stage converters for electric bike battery charging comprise of boost converter for PFC followed by dc-dc converter with universal-input voltage. These two-stage conversions suffer from poor efficiency and increased component count. In this paper, a single- stage switched inductor Cuk converter based power factor correction converter is proposed which offers high step-down gain, low current stresses, high efficiency and reduced component counts. The operational analysis and design equations for various components of proposed converter are carried out in continuous current mode (CCM). This paper presents mathematical modeling, analysis, simulation and experimentation on proposed converter rated for 500 W, 48V/10.4A. The performance investigation of proposed converter with respect to power quality indices like voltage THD, current THD and total power factor are carried out with various types of load such as resistive load and battery load in both constant voltage (CV) and constant current (CC). Furthermore, the dynamic performance of proposed converter with battery charging is investigated in constant voltage mode and constant current mode with respect to wide change of supply variations.
15 May 2018 in IEEE Transactions on Power Electronics
This paper describes a control algorithm based on modified enhanced phase-locked loop (MEPLL) in dynamic voltage restorer (DVR). It compensates distortions and unbalances in the supply voltage along with voltage sag/swell. Three-phase MEPLL extracts the fundamental positive-, negative-, and zero-sequence components from the distorted/unbalanced signals. Further fundamental positive-sequence components are used in the reference load voltage calculations. In addition to track the angle of the input signals similar to the conventional PLLs, the proposed algorithm (MEPLL) offers features of getting fundamental and sequential components in case of distorted or unbalanced grid voltage for all the three phases simultaneously. Optimization approach named as autonomous groups particle swarm optimization, a variant of PSO is used for the calculation of PI-controller gains. The integrated time square error is used as a cost function for optimization of an error between the reference and actual values. This approach of tuning PI gains improves the performance by eliminating the manual process. The proposed control algorithm is implemented in DVR system using MATLAB software and validated in a laboratory environment. The performance shows that the proposed control algorithm gives time effective and satisfactory solution for the unpredictable issues mentioned.
19 March 2020 in IEEE Transactions on Power Electronics
There is a consistent demand for reliable, efficient, small-sized, and light-weight on-board chargers for vehicular battery charging applications. In view of aforesaid requirements, these chargers are restricted to level-1 and level-2 charging. Therefore, it leads to larger charging time. The proposed charger is integrated with propulsion machine drive system that serves to utilize the high power-rated electrical machine and motor-drive voltage source converter to facilitate vehicular battery charging when the vehicle is not running. This paper presents mathematical modelling under various operational modes, analysis and design considerations for the proposed system configuration. The entire system is developed using Simulink and Sim Power System toolbox of MATLAB software and tested in real time implementation. The performance investigations of proposed charging system are carried out for vehicle battery charging under steady state as well as source variations. Furthermore, to ensure power quality features, total harmonic distortions of source voltage and current and input power factor, are monitored. The salient features of proposed systems include no additional circuit, on-board charger suitable for fast charging, plugged in with single-phase, 230V, 50 Hz outlet. It also offers reduction in switch stress, reduced filter size, less ripple in current and voltage and improve dynamic response.
7 March 2018 in IEEE Transactions on Industry Applications
In this paper Lorentzian norm based adaptive filter (LAF) is implemented to control Voltage Source Converter (VSC) for improvement in power quality of three phase four wire wind based distributed generation system. This control algorithm operates VSC to control the terminal voltage and frequency in allowable range. In addition to above, neutral current compensation, load balancing, reactive power and harmonic compensation are also carried out. Therefore, in the system the generator always supplies the active fundamental component of load current. The LAF is derived from a sliding window type objective function with Lorentzian norm of past errors to overcome bad effect of impulsive environment on system. Hence it is most suitable filter in wind based distributed generation system application in order to neutralize the effect of wind impulses on the voltage and frequency of the generator. The entire system comprises of induction generator, VSC, star-delta transformer and non linear load is developed in MATLAB SIMULINK followed by a prototype in the laboratory. The control performance of the said filter is evaluated and validated by simulation and experimental analysis. After performance observation, results are found satisfactory.
2 August 2022 in International Journal of Ambient Energy
Electric vehicles (EVs) are becoming increasingly popular, as the results of fossil fuels are going to be exhausted in the future. Although, the excessive use of electric vehicles is advantageous because it reduces the greenhouse gas emissions, but it also requires charging stations to recharge their batteries. In such a case, the Electric Vehicle Charging Station (EVCS) puts an additional burden on the utility grid which causes additional system power losses and voltage deviation. Furthermore, it also lowers the voltage stability index. To minimize the impact of EVCSs on the distribution system, charging stations are integrated into the distribution system in coordination with Distribution Static Compensator (DSTATCOM) and Distributed Generation (DG). In this paper, the African Vultures Optimization Algorithm (AVOA) is used to determine the optimal position of EVCSs, DGs, and DSTATCOMs. The objective function is to reduce the real power loss index and voltage deviation index while enhancing the voltage stability index. Also, the AVOA results are validated by comparing them to the results of the grey wolf optimizer algorithm. The suggested approach is examined on 33 bus, 69 bus, and 136 bus systems. Researchers, academics, industrialists, and society all benefited from this research work.
8 October 2018 in IEEE Transactions on Industrial Electronics
This paper addresses the compensation of power quality problems such as balancing of load, compensation of neutral current and distortions of the load current in wind based renewable energy system working at isolated location for small consumers. For this purpose, adaptive theory based momentum least mean square (M-LMS) algorithm is used to operate the Voltage Source Converter (VSC) which enhances the power quality in the system. This control is also responsible for keeping constant frequency and voltage at the point of common interface (PCI) under mechanical and electrical transients. In addition to it, the reactive power is also compensated. The M-LMS is a modified control of basic LMS that utilizes the past gradient information to reach improved adaptation performance instead of using its current value.This control has removed the drawback of LMS algorithms such as weight convergence dependency on selection of step size parameter. Moreover, it is observed that with inputs having high noise components, the M-LMS algorithm performs better. Therefore, the application of the proposed control seems better in wind based power generation where the input conditions are uncertain. The entire setup is developed in MATLAB/ SIMULINK as well as tested in real time implementation. The performance results are observed to be effective.