Zhutian Liu

Mr. Zhutian Liu


Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
2 November 2021 in IEEE Transactions on Geoscience and Remote Sensing
Verified
Journal Article
Closed access
Zhongyu LiZhongyu Li
Zhongyu Li
HYHongda Ye
Hongda Ye
ZLZhutian Liu
Zhutian Liu
ZSZhichao Sun
Zhichao Sun
HAHongyang An
Hongyang An
JYJianyu Yang
Jianyu Yang
Clutter suppression is a challenging task in synthetic aperture radar-ground moving target indication (SAR-GMTI). In general, sufficient secondary samples are not easily acquired due to the nonstationary and nonhomogeneous characteristics of bistatic SAR (BiSAR) clutter, resulting in worse clutter suppression results. Recently, space–time adaptive processing based on sparse recovery (SR-STAP) has been developed since its better clutter suppression performance with less samples. However, since the off-grid problem in space–time domain caused by BiSAR’s separate configuration, existing SR-STAP would suffer from severe performance degradation. To address this problem, a clutter-ridge matched STAP (CRM-STAP) method for BiSAR nonstationary clutter suppression is proposed. First, clutter distribution modeling with arbitrary BiSAR configuration is applied to accurately obtain the clutter ridge in space–time domain. Then, keystone transform and time-division processing are applied to correct range cell migration and eliminate Doppler frequency migration, respectively. Next, to solve the off-grid problem, the CRM dictionary is reconstructed via adaptive gradient method, which is established along the direction of clutter ridge and its orthogonal direction. Then, with the constructed CRM dictionary, the clutter covariance matrix (CCM) estimation process is transformed to a multimeasured vector optimization problem, and it can be directly solved by the sparse Bayesian learning algorithm. Finally, based on the estimated CCM, the CRM-STAP filter is built to suppress the nonstationary clutter effectively. Compared with the existing STAP and SR-STAP methods, this method can avoid the performance degradation in clutter suppression caused by the off-grid problem and overcomes the strong nonstationary problem of BiSAR clutter in heterogeneous environments. In October 2020, we have successfully carried out the world’s first airborne BiSAR-GMTI experiment, and the experimental results are given to verify the effectiveness of this method.

5 July 2021 in IEEE Transactions on Geoscience and Remote Sensing
Verified
Journal Article
Closed access
ZLZhutian Liu
Zhutian Liu
HYHongda Ye
Hongda Ye
Zhongyu LiZhongyu Li
Zhongyu Li
QYQing Yang
Qing Yang
ZSZhichao Sun
Zhichao Sun
JYJianyu Yang
Jianyu Yang
Clutter suppression in synthetic aperture radar (SAR) is one of the urgent and attractive problems in ground moving target indication (GMTI) application. With separate transmitter and receiver, ground clutter is nonstationary in bistatic forward-looking SAR (BFSAR), which directly leads to the inaccurate clutter covariance matrix (CCM) estimation. As a consequence, the traditional space-time adaptive processing (STAP) will suffer from a serious performance deterioration. In this article, an optimally matched space-time filtering (MSTF) technique is proposed to suppress nonstationary clutter for BFSAR systems. The main idea of the proposed method is to directly design and generate a suppression filter in space-time domain, whose space-time frequency response is matched with clutter spectrum. To construct the matched space-time filter, clutter modeling with arbitrary BFSAR configuration is first proposed to acquire space-time information of clutter spectrum. And then, the suppression filter can be designed and the design process is transferred into a constrained optimization problem (COP), according to the obtained clutter space-time information. Finally, the particle swarm optimization (PSO) algorithm is applied to solve the COP and obtain the optimal solution, i.e., the desired matched space-time filter weight, for BFSAR nonstationary clutter suppression. Since the generation of the designed filter circumvents CCM estimation, the proposed method will not be affected by the nonstationary characteristic of BFSAR clutter. In October 2020, the first airborne BFSAR-GMTI experiment in the world has been successfully conducted by us, and the experimental results are given to validate the effectiveness of the proposed method.

14 August 2020 in IEEE Journal of Selected Topics in Applied Earth Observations and Remote Sensing
Verified
Journal Article
Open access
ZLZhutian Liu
Zhutian Liu
Zhongyu LiZhongyu Li
Zhongyu Li
CHChuan Huang
Chuan Huang
JWJunjie Wu
Junjie Wu
JYJianyu Yang
Jianyu Yang
In real application scenario of bistatic forward-looking synthetic aperture radar (BFSAR), ground moving target (GMT) is generally smeared severely in SAR image, due to its unknown range cell migration (RCM) and Doppler frequency migration (DFM). When GMT moves along an unknown curve trajectory, its high-order RCM and DFM (including the second- and third-order terms) would further aggravate the difficulty of GMT refocusing. To address this issue, an efficient GMT refocusing method via keystone-based delay-correlation transform and fast searching Fourier transform (KDCT-FSFT) is proposed. First, the KDCT is proposed to correct the first- to third-order RCMs regardless of target's motion state and position information. Meanwhile, the order of GMT's phase response is reduced as well. Then, FSFT is applied to estimate the third-order Doppler parameter of GMT. In the following, a two-dimensional fast Fourier transform (2D-FFT) can be applied to integrate the target signal coherently in Doppler parameters domain, where the Doppler centroid and Doppler frequency rate of GMT can be estimated. Finally, with the aforesaid estimated Doppler parameters, RCM and DFM can be well corrected and target with unknown curve motion can be finely refocused. Compared with the existing methods, not only the refocusing accuracy of the proposed method is higher, but also its processing is more efficient, since the procedures in the proposed method are performed with respect to all the range cells in the corresponding aperture, i.e., GMT refocusing is achieved by the two-dimensional data received in one aperture, rather than along every single range cell.

21 September 2020
Verified
Conference Paper
Closed access
HYHongda Ye
Hongda Ye
Zhongyu LiZhongyu Li
Zhongyu Li
ZLZhutian Liu
Zhutian Liu
JWJunjie Wu
Junjie Wu
HYHaiguang Yang
Haiguang Yang
JYJianyu Yang
Jianyu Yang
Non-stationary clutter suppression is an attractive and challenging problem in space-time adaptive processing(STAP) algorithms. Although sparse recovery(SR) STAP can effectively alleviate strong clutter non-stationary characteristic with a few number of samples, there are still difficulties where the clutter components are not located on the discrete spacetime grid points of the dictionary, which results in significant performance loss. To overcome the off-grid problem, a clutter-ridge matched SR-STAP(CRM-SR-STAP) is proposed. In the proposed algorithm, clutter ridge is calculated at first according to prior knowledge including radar system parameters and modern inertial navigation system information. Then, the clutter-ridge matched dictionary is reconstructed to calibrate the uniformly discrete dictionary. Finally, the non-stationary clutter is suppressed by SR-STAP with this dictionary and the off-grid problem has been well-overcome. The proposed algorithm can effectively match the nonlinear characteristics of clutter under the non-side-looking array scenario, and the signal-to-interference-plus-noise ratio(SINR) loss also improves significantly. Simulations are given to verify the effectiveness of the proposed method.

24 July 2019 in The Journal of Engineering
Verified
Journal Article
Open access
PDF file
ZLZhutian Liu
Zhutian Liu
Zhongyu LiZhongyu Li
Zhongyu Li
QYQing Yang
Qing Yang
JWJunjie Wu
Junjie Wu
Yulin HuangYulin Huang
Yulin Huang
JYJianyu Yang
Jianyu Yang
Detecting ground moving target in bistatic forward‐looking synthetic aperture radar (BFSAR) has become increasingly important in military and civil field. Compared with pulse Doppler radar, the long observation time and high resolution of BFSAR will lead to three problems in the received signal: Doppler ambiguity, large range cell migration and Doppler cell migration, which tremendously aggravate the difficulty of ground moving target detection (GMTD). In this study, the authors propose a three‐step ground moving target detection method for BFSAR to solve these problems and achieve good performance on GMTD. First, the bulk‐deramp filtering and Keystone transform are exploited to suppress Doppler ambiguity and correct range cell migration, respectively. Then, time‐division space–time adaptive processing is utilised for clutter suppression, which eliminates the effect of the Doppler cell migration. Finally, modified Wigner–Ville distribution method is applied to further improve the signal to clutter and noise ratio and the moving target can be detected in the integration domain. Simulations are carried out to demonstrate the effectiveness of the proposed method.