Many renewable energy sources are not able to provide the demanded electrical energy during the day. This problem is getting more important with the increase of power plants which are based on renewable energy. The proposed method for overcoming the aforementioned problem is the building of hybrid power plants with two or three different energy sources. The most common hybrid power plants are solar-wind power plants, who produce electricity by using the complementary characteristics of solar irradiation and wind speed. The hybrid solar-wind power plants contain a lot of power electronic devices that affect the power quality disturbances. Therefore, an analysis of the dynamic of such power plants is necessary. First part of this paper presents the modeling of hybrid solar-wind power plants. The second part analyzes the impact on power quality of hybrid solar-wind power plant during its daily working cycle.
The paper describes a photovoltaic system (PVS) composed of a group of photovoltaic (PV) panels and presents the initial evaluation of power quality (PQ) in the low-power microgrid connected to these PV panels. This PVS is called solar tree and it is built as a research platform at our faculty to conduct teaching and research on renewable energy sources. The solar tree can operate in two modes: on-grid and off-grid (autonomous operation). An off-grid mode was analysed and experiments were carried out in order to determine the maximum power that can be delivered to the load connected to this autonomous photovoltaic system (APVS). Also, the various consumer's responses to a sudden load changes in this APVS were analysed. The experiments were carried out by using modern power quality monitoring devices and PQ of this single-phase APVS with energy storage is examined in terms of compatibility with the relevant international standards.
The contribution of renewable energy sources to the power system stability will have to be greater in the future. The problem will arise if the share of wind power plants in total production increases and large failures occur. Then, wind farms, which are often called inertia-less sources in the literature, will have to help maintain the frequency in a normal amount by changing the management method and based on fast PMU measurements. This can be done by using the synthetic inertia size, which is defined for sources that are derived from the system via energy converters and which do not participate in defining the total inertia of the system. This paper provides a better insight into the understanding of the concept of synthetic inertia, as well as insight into the current development of management and the application of synthetic inertia in maintaining the stability of the power system.
Renewable energy sources in addition to all the advantages over the non-renewable energy sources have a lot of limitations, where the biggest of them are the price and the inability of constant electricity generation. One way of overcoming the problem of inability of constant electricity generation is to build hybrid power plants with renewable energy sources. This primarily highlights hybrid solar — wind power plants, which produce electricity by using solar radiation and wind energy. Since the hybrid solar — wind power plants consist of a photovoltaic power plant and a wind power plant and are usually constructed as a distributed source, it is necessary that the regulatory frameworks define criteria and actions for the connection of a hybrid solar — wind power plant in the power system. This paper gives a short overview of criteria and actions for the connection of a hybrid solar — wind power plant in the power system according to official documents in Bosnia and Herzegovina.
In the transition from non-renewable to renewable energy sources, wind and solar power plants have emerged as primary sources for reducing atmospheric emissions. However, ensuring grid stability remains a challenge in the absence of traditional power plants. Renewable energy sources are often referred to as “inertia-less,” highlighting their vulnerability in transient stability scenarios in which system inertia is crucial. This paper introduces the concept of “synthetic inertia estimation” using an Extended Kalman Filter as a novel solution. Using the synthetic inertia estimation from a wind power plant, one can use the residual kinetic energy, and through the DC/AC converter, inject it into the system during times of stability disturbances. This paper offers practical insights into synthetic inertia estimation and its implementation for enhancing grid stability in a sustainable energy landscape.