A novel lattice matched double barrier Al0.72In0.16Ga0.12N/Al0.18In0.04Ga0.78N/GaN normally-off high electron mobility transistor (HEMT) is designed and simulated by solving a set of thermodynamic transport equations. Using the experimentally calibrated physical models with bearing mobility degradation by surface roughness in account, the recess gate and double barrier of the proposed device achieves a maximum drain current density (IDS,max) of 1149 mA/mm and a maximum transconductance (gm,max) of 358 mS/mm with a positive threshold voltage (Vth) of 0.2 V. The small polarization charge of first barrier is responsible for positive Vth. IDS,max in the double barrier HEMT at high gate bias condition is due to injection of electrons from upper 2DEG which is almost impossible at lower gate voltage because of insufficient energy to cross the barrier. The injection of electrons is further supported by the second peak in the gm curve at low gate bias VG = 1V. The outcome of this study suggests that the proposed device will be beneficial for high-frequency and high-power electronic applications.
β-Ga2O3 is a highly promising ultrawide bandgap semiconductor material that is poised to transform the high-power electronics field. The manufacturability of device quality β-Ga2O3 epitaxial films at scale is urgently needed. Using a production-ready closed-coupled showerhead MOCVD reactor with in situ reflectance monitoring, this study presents a detailed investigation of the impact of growth parameters on the epitaxial growth of β-Ga2O3 on both (010) and (001) oriented native substrates, as well as on c-plane sapphire substrates with 0°–8° off-axis orientations. By tuning the showerhead–susceptor gap and mapping the other growth parameters, including annealing, nucleation, growth temperature, reactor pressure, and substrate orientation, we achieved state-of-the-art crystal quality, extraordinary wafer-level thickness uniformity of <1% variation for both 2-in. and 4-in. substrates for growth rates as high as 7.2 μm/h. All growth was performed using TMGa and pure O2 as the precursors and N2 as the carrier gas instead of the more widely used argon; no detectable nitrogen and carbon incorporation was observed by secondary ion mass spectrometry. For the homoepitaxy of Si-doped β-Ga2O3 films on (010) substrates, a room temperature Hall mobility of 148 cm2/V s was achieved at a carrier concentration of 1.26 × 1017 cm−3, with a growth rate of 2.6 μm/h. For the heteroepitaxy on sapphire, off-axis substrates exhibited enhanced crystallinity, as shown by the continued reduction of x-ray diffraction rocking curve full width at half maximum from 2834 to 1300 arcsec for 0° and 8° offcut sapphire substrates, respectively. The results demonstrate the scalability and potential advantages of this reactor design for manufacturing-scale β-Ga2O3 growth and offer new insights into the controllability of uniform high-quality films for power electronics applications.
8 December 2020 in IEEE Journal of the Electron Devices Society
This work demonstrates high-performance AlInGaN/AlN/GaN high electron mobility transistors grown on 150 mm p-type low resistivity (resistivity 20-100 Ω-cm) silicon substrate with state-of-the-art Johnson’s figure-of-merit (JFOM). Current gain cut-off frequency (fT) of 83 GHz and 63 GHz and power gain cut-off frequency (fmax) of 95 GHz and 77 GHz with a three-terminal off-state breakdown voltage of 69 V and 127 V, resulting in a high JFOM of 5.7 THz-V and 8.1 THz-V are achieved on the devices with a gate length of 0.16 μm and gate to drain distance of 2 μm and 4 μm, respectively. The fT and J-FOM are comparable or better than the reported values obtained on high resistivity silicon and SiC substrates for devices with similar gate length. On the other hand, GaN-on-Si HEMT structure on the LR-Si substrate exhibits lower power gain and power added efficiency due to strong capacitive coupling effects. TCAD large signal output power simulation indicates significant improvements in output power by minimizing the defects and free charge carriers in the GaN buffer even in the presence of the parasitic channel conduction and conductive silicon substrate. We further propose a modified equivalent circuit model of the parasitic conduction to take into account the conductivity of the GaN and AlGaN buffer.
Heteroepitaxy of gallium oxide (Ga2O3) is gaining popularity to address the absence of p-type doping, limited thermal conductivity of Ga2O3 epilayers, and toward realizing high-quality p-n heterojunction. During the growth of β-Ga2O3 on 4H-SiC (0001) substrates using metal-organic chemical vapor deposition, we observed formation of incomplete, misoriented particles when the layer was grown at a temperature between 650 °C and 750 °C. We propose a thermodynamic model for Ga2O3 heteroepitaxy on foreign substrates which shows that the energy cost of growing β-Ga2O3 on 4H-SiC is slightly lower as compared to sapphire substrates, suggesting similar high-temperature growth as sapphire, typically in the range of 850 °C-950 °C, that can be used for the growth of β-Ga2O3 on SiC. A two-step modified growth method was developed where the nucleation layer was grown at 750 °C followed by a buffer layer grown at various temperatures from 920 °C to 950 °C. 2θ-ω scan of X-ray diffraction (XRD) and transmission electron microscope images confirm the β-polymorph of Ga2O3 with dominant peaks in the (-201) direction. The buffer layer grown at 950 °C using a "ramp-growth" technique exhibits root-mean-square surface roughness of 3 nm and full width of half maxima of XRD rocking curve as low as 0.79°, comparable to the most mature β-Ga2O3 heteroepitaxy on sapphire, as predicted by the thermodynamic model. Finally, the interface energy of an average Ga2O3 island grown on 4H-SiC is calculated to be 0.2 J/m2 from the cross-section scanning transmission electron microscope image, following the Wulff-Kaishew theorem of the equilibrium island shape.
A significant improvement in electron mobility has been achieved by several authors on AlInGaN/GaN heterostructures by adding a small amount of Ga to the AlInN alloy. In this study, we propose that thermodynamic stability plays an important role in controlling the electron transport properties of these heterostructures. A quantitative investigation of the thermodynamic stability of the AlInGaN barrier has been carried out analytically, for a wide range of compositions (0.5 ≤ Al ≤ 0.8; In = 0.2, 0.15, 0.1). A slow change in the thermodynamic stability is observed when the Ga atoms replace only the Al atoms. In contrast, a significant improvement in thermodynamic stability is observed when the indium atoms are replaced by the Ga atoms in the same Al0.83In0.17N layer. It is found that the Al content in the range of 65%–70% with 10% In exhibits the highest thermodynamic stability within the calculated composition range owing to the significant reduction in total elastic strain in the barrier. Thereby, it leads to the highest electron mobility, as evidenced by the experimental observations in this work, i.e., electron mobility of 2090 cm2/V s with a sheet carrier density of 1.09 × 1013 cm−2. Therefore, the thermodynamic stability apart from commonly observed scattering mechanisms may at least be partially held to be responsible for the consistent improvement in electron mobility in AlInGaN/GaN heterostructures.
In this work, conventional deep-level transient spectroscopy (DLTS) and high-resolution Laplace-DLTS (L-DLTS) have been used to characterize deep-level traps in (010) β-Ga2O3 epilayers grown by metal organic chemical vapor deposition on native Sn-doped substrates. Two types of epilayers have been studied, one doped with silicon during growth to about 1.5 × 1017 cm−3 and the other type was unintentionally doped (UID). Electrical measurements were conducted on Au and Pt Schottky barrier diodes. In the Si-doped samples, only one electron trap with emission activation energy of 0.42 eV (E0.42) and concentration of (6–8) × 1013 cm−3 has been detected. In the UID samples, in addition to the E0.42 trap, two other traps with activation energies for electron emission of 0.10 eV (E0.10) and 0.53 eV (E0.53) have been observed. Dependencies of electron emission rate (eem) on the electric field (E) as well as concentration-depth profiles {NT(W)} have been measured and analyzed for the E0.10 and E0.42 traps. The eem(E) dependence for the E0.10 trap is characteristic for a donor energy level, while that for the E0.42 trap indicates an acceptor level. The NT(W) dependencies show non-uniform spatial distributions of both the E0.10 and E0.42 traps in the UID samples, with the concentration of the E0.10 trap dropping from about 1 × 1015 cm−3 at 1.5 μm from the surface to about 2 × 1013 cm−3 at 0.5 μm, which indicates out-diffusion from the substrate or interface into the epilayer as a likely source. The results obtained are compared with the literature, and possible origins of the detected traps are discussed.