As an effective technology for enhancing oil recovery, low-salinity water flooding requires further investigation into its microscopic displacement mechanisms and the regulatory roles of key ions. Based on microscopic visualization displacement experiments, this study systematically investigated the effects of injected water salinity, key ion types (Na⁺, K⁺, Ca²⁺, Mg²⁺, HCO₃⁻, CO₃²⁻, SO₄²⁻, and OH⁻), and their concentrations on crude oil displacement behavior in both high- and low-permeability zones. Experimental results indicate that no significant correlation exists between displacement efficiency and injected water salinity in high-permeability zones. In low-permeability zones, displacement efficiency increases with decreasing salinity, peaking at 26.5% when injected water salinity reaches 5000 mg/L. The cation displacement efficiency in the formation, from highest to lowest, is Ca²⁺ > K⁺ > Mg²⁺ > Na⁺. The anion displacement efficiency, from highest to lowest, is OH⁻ > SO₄²⁻ > CO₃²⁻ > HCO₃⁻. When the CaCl₂ concentration decreased from 100 wt% to 50 wt%, the displacement effect in the low-permeability zone improved further, indicating that a higher concentration of the divalent cation Ca²⁺ is not necessarily better. In medium-to-high salinity formation water reservoirs, and under conditions where the influence of clay minerals is disregarded, ion type and reservoir permeability are the most significant factors affecting oil recovery efficiency. These findings provide theoretical support for elucidating the micro-dynamic mechanisms of low-salinity water flooding in low-permeability zones and optimizing injection water formulations.

To address the insufficient consideration of osmotic pressure in existing studies on water huff-and-puff in tight oil reservoirs, this paper introduces both osmotic and capillary pressures into two-phase flow theory and develops a full-cycle model for low-salinity water injection. The effects of salinity, injection rate, and soaking time on pressure, saturation, and salt concentration are analyzed. Results show that lower salinity enhances osmotic drive and improves recovery. Specifically, 1000 mg/L yields the highest recovery (10.94%) and an osmotic gradient of ~3.9 MPa. Capillary pressure acts synergistically with osmotic pressure during the soaking stage, promoting spontaneous imbibition and fluid redistribution. An optimal injection rate exists: excessive rates reduce swept volume, while very low rates prolong the cycle. Quantitatively, 80 m³/d is preferred (recovery 10.94%) over 40 m³/d (11.13%) as it halves the injection time with comparable recovery. There is also an optimal soaking time beyond which incremental gain diminishes. Recovery rises from 9.32% at 20 d to 10.94% at 40 d, with only 0.28% and 0.20% gains afterward; thus, 40 d is optimal. The model captures osmotic-driven behavior and reveals the secondary displacement effect during soaking, supporting parameter optimization.