Reconfigurable intelligent surfaces (RISs) are a promising technology for sixth-generation (6G) wireless networks. However, a fully passive RIS cannot independently process signals. Wireless systems equipped with it often encounter the challenge of large channel matrix dimensions when acquiring channel state information using pilot-assisted algorithms, resulting in high pilot overhead. To address this issue, this article proposes a semi-blind joint channel and symbol estimation receiver without a pilot training stage for RIS-aided multiple-input multiple-output (MIMO) (including massive MIMO) communication systems. In a semi-blind system, a transmission symbol matrix and two channel matrices are coupled within the received signals at the base station (BS). We decouple them by building two parallel factor (PARAFAC) tensor models. Leveraging PARAFAC tensor decomposition, we transform the joint channel and symbol estimation problem into least square (LS) problems, which can be solved by Alternating Least Squares (ALSs). Our proposed scheme allows duplex communication. Compared to recently proposed pilot-based methods and semi-blind receivers, our results demonstrate the superior performance of our proposed algorithm in estimation accuracy and speed.
Reconfigurable intelligent surface (RIS) demonstrates significant potential in millimeter-wave (mmWave) multiple-input multiple-output (MIMO) wireless communication systems. However, the introduction of RIS leads to a substantial number of parameters in the channel matrix, making channel estimation highly challenging. By exploiting the sparsity of mmWave channels, compressed sensing algorithms, such as the orthogonal matching pursuit (OMP) algorithm, can significantly reduce the pilot overhead. Nevertheless, traditional OMP algorithms typically require extensive prior knowledge about the number of effective paths, which is often difficult to obtain. To address this problem, we propose a novel multi-user joint correlation allocation (MUJCA) algorithm, which requires only minimal and easily measurable prior information. Our key idea is to divide the RIS coverage area into multiple sub-regions, each associated with a known number of scatterers, which is a pre-measured quantity, with users distributed within these sub-regions. Then, the MUJCA algorithm exploits joint correlation of multiple users to facilitate sparse channel recovery and transforms it back into the spatial channel. Simulation results show that the proposed MUJCA achieves higher channel estimation accuracy than existing benchmark algorithms.
Reconfigurable intelligent surface (RIS) technology is a promising enabler for 6G communication systems due to its ability to reconfigure wireless propagation environments. However, as a passive device, RIS requires significant pilot overhead for accurate channel estimation. Moreover, the integration of RIS with multiple-input multiple-output (MIMO) systems further exacerbates power consumption and hardware costs. To address these challenges, this paper investigates RIS-assisted millimeter-wave (mmWave) MIMO systems with low-resolution analog-to-digital converters (ADCs). Exploiting the inherent sparsity of mmWave channels and considering the distortion introduced by low-resolution quantization, we propose a compressive sensing (CS)-based channel estimation scheme. Furthermore, to mitigate the effects of angular leakage, we introduce an energy capture orthogonal matching pursuit (ECOMP) algorithm. Simulation results demonstrate that the proposed scheme not only improves channel estimation accuracy but also reduces pilot overhead and power consumption, while maintaining enhanced stability in high signal-to-noise ratio (SNR) regimes.