We investigate the stability of the steady vertical path and the emerging trajectories of a buoyancy-driven annular disk as the diameter of its central hole is varied. The steady and axisymmetric wake associated with the steady vertical path of the disk, for small hole diameters, behaves similarly to the one past a permeable disk, with the detachment of the vortex ring due to the bleeding flow through the hole. However, as the hole diameter increases, a second recirculating vortex ring of opposite vorticity forms at the internal edge of the annulus. A further increase in the hole size leads to the shrinking of these recirculating regions until they disappear. The flow modifications induced by the hole influence the stability features of the steady and axisymmetric flow associated with the steady vertical path. The fluid-solid coupled problem shows a nonmonotonic behavior of the critical Reynolds number for the destabilization of the steady vertical path, for low values of the disk's moment of inertia. However, for very large holes, with dimension approximately more than half of the external diameter, a marked increase of the neutral stability threshold is observed. The nature of the primary instability changes as the hole size increases, with large (small) amplitude oscillations of the trajectory at intermediate (very small and large) internal diameters. We then illustrate results obtained with fully nonlinear simulations of the time-dependent dynamics, together with a comparison of the linear stability analysis results. Falling styles, typically described as steady, hula-hoop, fluttering, chaotic, and tumbling, are shown to emerge as attractors for the nonlinear dynamics of the coupled fluid-structure system. The presence of a central hole does not always reduce the falling Reynolds number, and it may cause the transition from tumbling towards fluttering, from fluttering to hula-hoop, and from hula-hoop to steady, hence promoting trajectories with smaller lateral deviations from the vertical path. The observed trajectories and patterns agree well with linear stability analysis results, in the vicinity of the threshold of instability.
11 May 2024 in Computer Methods in Applied Mechanics and Engineering
Biological, biomimetic, and engineering systems make extensive use of hydraulic asymmetries to control flow inside tubular structures. Examples span physiological valves, the guided transport observed in shark intestines, and passive devices such as Tesla valves. Here we investigate the mechanisms that generate these asymmetries using the notion of diodicity, defined as the ratio between pressure drops required to drive the same flow in opposite directions. We first focus on 2D geometries, which allow us to identify and study the main contributions to hydraulic asymmetry: channel geometry and internal obstacles embedded within a channel with rigid walls. By considering both rigid and deformable obstacles, we model channels that always remain open in both directions and channels that can be completely blocked by valve-like structures. We then extend the analysis to 3D geometries, again considering rigid and elastic cases. As a general trend, we find that geometry alone establishes a baseline diodicity, while higher dimensionality and structural reconfiguration consistently amplify the effect.
We study both experimentally and numerically the aeroelastic response of a pre-stressed curved aileron in a high Reynolds number flow undisturbed at infinity. The structure is designed to have a peculiar nonlinear behavior. Specifically, the aileron has only one stable equilibrium when the external forces are vanishing, but it is bistable when distributed aerodynamic loads are applied. Hence, for sufficiently high fluid velocities, another equilibrium branch is possible. We test a prototype of such an aileron in a wind tunnel. A sudden change (snap) of the shell configuration is observed when the fluid velocity exceeds a critical threshold: the snapped configuration is characterized by sensibly lower drag. However, when the velocity is reduced to zero, the structure recovers its initial shape. A similar nonlinear behavior can have important applications for drag-reduction strategies since the transition between a bluff body-like and a slender body-like behavior is controlled by the free-stream fluid velocity and does not require any external actuation.