Precise data on the non-variant equilibrium of the four phases (vapor–aqueous solution–ice–gas hydrate) in P–T coordinates are highly desired for developing accurate thermodynamic models and can be used as reference points (similar to the triple point of water). Using the two-component hydrate-forming system CO2–H2O, we have proposed and validated a new express procedure for determining the temperature and pressure of the lower quadruple point Q1. The essence of the method is the direct measurement of these parameters after the successive formation of the gas hydrate and ice phases in the initial two-phase gas–water solution system under intense agitation of the fluids. After relaxation, the system occurs in the same equilibrium state (T = 271.60 K, P = 1.044 MPa), regardless of the initial parameters and the order of crystallization of the CO2 hydrate and ice phases. Considering the combined standard uncertainties (±0.023 K, ±0.021 MPa), the determined P and T values agree with the results of other authors obtained by a more sophisticated indirect method. Validating the developed approach for systems with other hydrate-forming gases is of great interest.
Clathrate hydrates of carbon dioxide represent a subject of considerable interest in both fundamental science and the development of promising technologies. The phase behavior of CO2 hydrate in the presence of concentrated aqueous solutions remains poorly understood. In this study, we conducted a comprehensive investigation into the impact of magnesium chloride (0–24 mass%) and methanol (0–40 mass%) on the thermodynamic stability of CO2 hydrate. New experimental data on the three-phase gas–aqueous solution–gas hydrate equilibrium in the temperature range 243–283 K and pressure range 1–4.5 MPa were obtained. A correlation is proposed for the precise representation of equilibrium pressure–temperature lines. A comparison of the anti-hydrate effect, as indicated by the parameter ∆Th, of these substances demonstrated that ionic MgCl2 exhibits a stronger thermodynamic inhibitory effect on CO2 hydrate formation than nonionic MeOH. The results of measuring the melting point of ice at 0.1 MPa for aqueous solutions of MgCl2 and MeOH confirmed the thermodynamic consistency of the hydrate equilibrium data. A detailed comparison of the anti-hydrate effect of MgCl2 and MeOH in a wide concentration range was performed on hydrates of different gases (CO2 and CH4). The phase composition of CO2 hydrate samples obtained from water and aqueous solutions of MgCl2 and MeOH was examined using powder X-ray diffraction (PXRD) at 133 K. The PXRD results indicate the formation of sI CO2 hydrate with a cell parameter of 11.86 ± 0.04 Å in all cases.
A comparative analysis is carried out of the most well-known calculation models developed for determining the critical temperature of hydrocarbons, primarily those in the homologous series of n-alkanes. The main advantages and disadvantages of correlations proposed in the literature are noted. A refined correlation is proposed for determining the critical temperature of normal and branched alkanes, applicable to homologs with the number of carbon atoms from NC = 3–7 and practically up to 100 or more. A comparison is provided between the results of calculations using the proposed correlation and those based on correlations by other authors. The advantage of the proposed correlation for the critical temperature of individual compounds is highlighted compared to polynomial and complex nonlinear models, namely, the ability to extend the adopted approach to compounds of other structural groups and to predict the critical temperatures of homologous series with limited or even no experimental reference data.
Currently, two thermodynamic hydrate inhibitors are used in Russia: methanol and monoethylene glycol (MEG). Application of MEG is primarily driven by environmental aspects. However, using MEG in Russian gas condensate fields has several drawbacks: to reduce viscosity and the freezing point, it must be diluted with water, which reduces its anti-hydrate activity. This paper discusses a mixture of two thermodynamic inhibitors. The mixed inhibitor methanol + MEG (with MEG predominating in the mixture), combines the low content of methanol vapor in natural gas with the low freezing point and viscosity of the inhibitor solution. This paper considers the methodology of MEG + methanol inhibitor application, as well as the calculation technique of specific inhibitor consumption for hydrate control in a low-temperature gas separation unit (LTS), particularly in offshore gas condensate fields. Using a mixed inhibitor instead of an aqueous MEG solution (80 wt %) has been shown to reduce specific inhibitor consumption by up to two times. This approach also allows lowering the gas separation temperature from –23 to –30°C, which increases the yield of hydrocarbon condensate. The potential of dual-reagent technology at underground gas storage (UGS) facilities is also being analyzed. Wells and gas gathering systems are treated with methanol, and concentrated aqueous MEG is fed to the LTS unit to form a mixed inhibitor directly in the unit. This approach decreases the technological losses of methanol with the treated gas, thereby reducing the overall loss of the inhibitor.