This paper presents the design, development, and measurement results of a low-cost integrated circularly polarized active phased-array antenna (CP-APAA) technology with sidelobe level control, operating at Ka-band, for high throughput land-mobile satellite communication. The proposed CP-APAA comprises of (4 × 16) 64 elements in a rectangular grid array configuration. Eight commercial monolithic microwave integrated circuits (MMICs) with 8-RF output channels have been used to control the phase and amplitude over the antenna aperture. For simplicity, the array antenna was designed in three metal layers and fabricated by a low-cost printed circuit board (PCB) technology as a proof-of-concept for a modular and scalable Ka- band phased-array antenna with a wide steering angle. Measured radiation pattern shows a right-hand circularly polarized (RHCP) pattern with an axial-ratio (AR) level <3dB and low pointing error ≤ 1.5° over a scanning angular range of 0°–×40°. Moreover, the amplitude excitation of the CP-APAA was tapered exponentially to control and reduce the side lobe level from 11 dB to 25 dB in boresight direction. Finally, towards a multi-beam array implementation, a two RHCP beams have been generated at –30° and +20° scan angles simultaneously.
31 October 2018 in IEEE Transactions on Antennas and Propagation
This paper presents a low-profile, high-performance, and low-cost Ka -band circularly polarized (CP) passive phased-array antenna (PAA) system. A $1\times 4$ passive subarray operating at the Ka -band frequency band is investigated, developed, and tested as a possible building block for mobile satellite communication systems. In particular, a CP antenna integrated with a high-performance passive phase shifter is presented and experimentally verified. A new low-cost and low-profile magnetic actuator is proposed to precisely control the phase state of the phase shifter. A 3-D printed polymer package is utilized to enclose the phase shifter and reduce the environmental effects. The proposed CP passive PAA achieves high-performance right-hand CP radiation with high cross-polarization discrimination over a wide scan angle from 0° to ±38° over the frequency band (29.5–30.5 GHz). An axial ratio (AR) < 3 dB is demonstrated over the entire scanning range. Moreover, the measured radiation efficiency is 60% at boresight. The gain drops by 1 dB at ±38° scanning angles.
7 August 2018 in IEEE Antennas and Wireless Propagation Letters
This letter presents the design of a wideband circularly polarized antenna, operating at Ka band. The proposed antenna comprises a circular microstrip patch antenna that is coupled to a microstrip feedline through a modified L-shaped aperture slot. The antenna radiates a wideband right-hand circularly polarized wave with high polarization purity and a wide axial ratio (AR) angular beamwidth. A 4 × 4 antenna subarray has been designed, fabricated, and measured to validate the proposed concept. The array exhibits a reflection coefficient S11 <; -10 dB over the frequency band 27-31 GHz. Moreover, the 4 × 4 antenna subarray yields a high level of polarization purity, as well as a flat measured AR ≤ 1.15 dB over the frequency range 27.55-30.45 GHz (10% bandwidth).
1 December 2022 in IEEE Transactions on Antennas and Propagation
This article covers the implementation, calibration, and measurement aspects of a low-profile 4×4 passive phased-array Antenna-in-Package (AiP) employing the beamformer discussed in [9]. The antenna array comprises slot-coupled patch antennas with left-handed circularly-polarized (LHCP) radiation. MEMS-like tunable phase shifter functioning based on controlling the phase constant of a slow-wave microstrip line is employed for the phase tuning. Measurement results show the antenna’s main beam can be steered over an angular range of ±30° in both elevation and azimuth planes. The operating frequency bandwidth of the system ranges from 28-30 GHz. The peak directivity and the radiation efficiency of the antenna system are 18.48 dBic and 58 % at Boresight at 29 GHz, respectively. The efficiency drops 16% when the steering angle reaches the maximum.
This paper presents new microstrip devices as single band bandpass and multi band bandstop filters. The proposed filters use slotted patch microstrip resonator based on quasi fractal geometry, simulated by AWR12 software package. Both filters have quasi elliptic frequency response, designed at centre frequency of 2.437 GHz for bandpass filter and at band frequencies of 2.434, 4.032, 4.976 and 5.638 GHz GHz respectively, for multi bandstop filter. All filters are employed using RT/Duroid 6010.8 LM substrate of dielectric constant and 1.27 mm dielectric thickness. Simulation results show that the designed quasi fractal bandpass filter has very narrow fractional bandwidth of 0.38 % which is very rare in microstrip filter design. On the other hand, the projected bandstop filter offers multi narrow rejection bands that is useful in broadband wireless schemes influencing from fixed interferences. Both filters present satisfactory S11 and S21 responses besides smallness properties that stand for interesting features of the newest wireless applications. The simulated and measured frequency responses for both designed filters are in good agreement.
22 October 2018 in Wireless Personal Communications