We reveal the existence of a previously unknown fault that generated the 7.3 Flores Sea earthquake, which occurred on 14 December 2021, approximately 100 km to the north of Flores Island, in one of the most complex tectonic settings in Indonesia. We use a double‐difference method to relocate the hypocenters of the mainshock and aftershocks, determine focal mechanisms using waveform inversion, and then analyze stress changes to estimate the fault type and stress transfer. Our relocated hypocenters show that this earthquake sequence ruptured on at least three segments: the source mechanism of the mainshock exhibits dextral strike‐slip motion (strike N72°W and dip 78° NE) on a west–east‐trending fault that we call the Kalaotoa fault, whereas rupture of the other two segments located to the west and east of the mainshock (striking west‐northwest and southeast, respectively) may have been triggered by this earthquake. The Coulomb stress change imparted by the rupture of these segments on nearby faults is investigated, with a focus on regions that experience a stress increase with few associated aftershocks. Of particular interest are stress increases on the central back‐arc thrust just north of Flores and the north–south‐striking Selayar fault in the northwest of our study region, both of which may be at increased risk of failure as a result of this unusual earthquake sequence.
1 March 2020 in Journal of Physics: Conference Series
This study aims to investigate site conditions based on the dominant period and elliptical curve inversion of Horizontal-to-Vertical Spectral Ratio (HVSR). The data were taken using a seismometer portable short period in the minimum time span of data retrieval for 30 minutes. The Nakamura method as known as Horizontal-to-Vertical Spectral Ratio (HVSR) is used to obtain the value of the dominant frequency and amplification factor. The dominant frequency is changed to the dominant period which can indicate the type of soil. HVSR processing use Geopsy software with a guide from the SESAME Project. The results of processing show that the dominant frequency and the amplification factor. In Geopsy there are several modules and packages. This processing uses TFA Module and Max2curve Package and Dinver Package. Waveform can be inversed based on the elliptical curve of HVSR model to produce a shear wave velocity model (Vs) uses that modules and packages. From the velocity model, we can know Vs30 to determine the type of soil layer. The shear wave velocity model obtained can show the estimation of sediment thickness in the area under investigation.
23 November 2022 in Geotechnical and Geological Engineering