MOFs-derived magnetic carbon-based composites are considered to be valuable materials for the design of high-performance microwave absorbents. Regulating phase structures and introducing mixed-valence states within the composites is a promising strategy to enhance their charge transfer properties, resulting in improved microwave absorption performance. In this study, iron oxide components show a temperature-dependent phase evolution process (α-Fe2O3→Fe3O4→Fe3O4/FeO), during which the valence states of iron ions are regulated. The tunable phases modulate the magnetic Fe3O4 component, resulting in enhanced magnetic loss. The changed valence states affect the polarization relaxation by adjusting the electronic structure and tune the electron scattering by introducing defects, leading to enhanced dielectric loss. The microwave absorption properties of iron oxide@carbon composites display phase- and valence state-dependent characteristics. Especially, Fe3O4@C composites exhibit superior microwave absorption properties, ascribed to the improved magnetic/dielectric losses induced by good impedance matching and strong microwave attenuation capacity. The minimum reflection loss of Fe3O4@C composites reaches −73.14 dB at 10.35 GHz with an effective absorption bandwidth of 4.9 GHz (7.69–12.59 GHz) when the absorber thickness is 2.31 mm. This work provides new insights into the adjustment of electromagnetic parameters and microwave absorption properties by regulating the phase and valence state.
A new type of orange emission carbon dots (OCDs) was prepared by hydrothermal method using 1,2,4‐triaminobenzene and p‐aminobenzenesulphonic acid as precursors. TEM characterization showed that the new OCDs were uniform in size with an average particle size of 4–7 nm. Infrared spectroscopy and XPS analysis showed that the surface of the OCDs were rich in hydrophilic functional groups. Fluorescence spectroscopy results showed that the obtained OCDs exhibited excellent fluorescence with an absolute quantum yield as high as 14.9%. The OCDs were further applied to the detection of metal ions. It was found that the fluorescence of OCDs could be effectively quenched by Cr(Ш) with a detection limit of 0.38 μ m . Notably, the obtained OCDs have been successfully used for fluorescence detection of Cr 3+ ions in cell level.
Cellulose nanofibrils (CNFs), with their high aspect ratio, have been widely used in various resin-based composites. To address the issues of easy agglomeration and poor interfacial compatibility of CNFs in hydrophobic acrylate photosensitive resins, this study adopted γ-methacryloyloxypropyltrimethoxysilane (KH570) for silane modification of CNFs, comparing heating–ultrasonication and heating–stirring methods. Mechanical properties were tested via LCD 3D printer to print splines. FTIR, XRD, and SEM verified successful modification, with the silicon substitution degree of heating–ultrasonication modification reaching 29.35%, significantly higher than heating–stirring (22.76%). Thermal analysis showed the main decomposition temperature increased from 400 °C to 420 °C, while DMA confirmed improved rigidity and glass transition temperature. Mechanical tests revealed a strength–toughness trade-off: the 1 wt% modified CNF composite exhibited a tensile strength of 45.17 MPa (9.41 MPa higher than unmodified CNFs at the same dosage), while a high dosage (3.5 wt%) enhanced toughness but reduced strength. The ultrasound-assisted silanization reaction proposed in this study optimizes the preparation process, achieving dual improvements in modification efficiency and dispersion. In terms of performance regulation, it reveals the quantitative control rules and trade-off characteristics of modified CNF content on the mechanical–thermal properties of the composites, providing a basis for performance customization. This study provides a feasible strategy for CNF modification in photopolymerizable 3D printing composites, expanding nanocellulose’s application in additive manufacturing.
10 March 2026 in Chinese Journal of Polymer Science