Adhesiveness is a property that directly affects the service life of asphalt pavements. Over the years, different materials, research methods and tests have been used to investigate different adhesiveness aspects of materials. This paper investigated two asphalt binders, one with and one without amine-based anti-stripping agent, as well as two aggregate sources. The objective was to investigate the effects of rheology (stiffness and rutting) of the asphalt binder and adhesiveness of asphalt binders to different substrates on the resistance to moisture conditioning. The results indicated that moisture conditioning reduced the average stiffness of the binders by about 15% for both binders. The addition of amine-based anti-stripping agent reduced the stiffness of the neat binder by approximately 9%, and at 82°C the neat binder presented higher rutting resistance if compared to the modified binder using anti-stripping agent. The aggregate area within the HMAs in contact with asphalt binder did not show a good correlation with the pull-off tensile strength in the dry condition, but it presented good correlation after moisture conditioning. This suggests that adhesion force itself may not be greatly affected by the proper contact between aggregate and binder, but such contact does help preventing moisture damage in the interface.
Não há consenso quanto aos efeitos do uso de amostras moldadas ou extraídas para a caracterização mecânica de misturas asfálticas. O objetivo deste artigo é avaliar o efeito do uso de corpos de prova (CPs) moldados e extraídos de uma mistura asfáltica, fazendo uso de ensaios uniaxiais e triaxiais de deformação permanente, uniaxiais de fadiga por tração-compressão e módulo dinâmico, além de resistência à tração indireta e módulo de resiliência. A variação de granulometria e o teor de ligante nos CPs moldados e extraídos também foram avaliados. Observou-se maior sensibilidade nos ensaios de deformação permanente, seguido por módulo dinâmico e fadiga por tração-compressão. Os ensaios de módulo de resiliência e resistência à tração indireta não apresentaram variação significativa quando comparados os dois tipos de corpos de prova investigados.
The complex modulus is one of the intrinsic properties of bituminous materials, and, hence, is of importance for their rheological characterization. It was shown by various authors that the complex modulus of asphalt mixtures can be calculated from dynamic modulus measurements using the Resonant Acoustic Spectroscopy (RAS). This paper extends the RAS technique to bitumen. For the purpose of validation, rheological data for the same bitumen are also derived from standard Dynamic Shear Rheometer (DSR) tests, and the master curves resulting from both methods are compared. The laboratory programme comprised a temperature range from −30 °C to 20 °C, and four different bitumens in unaged and aged condition, resulting in 36 different test variants. RAS successfully characterizes the complex modulus of bitumen and reflects temperature and ageing effects, with good agreement to DSR results at low temperatures. At higher temperatures, viscosity and damping introduce deviations, indicating that RAS is effective for modulus evaluation but not sufficient for complete master curve development.