Nitrogen oxides (NOx) emitted mainly from vehicle exhaust significantly contribute to urban air pollution, leading to photochemical smog and secondary particulate matter. Photocatalytic technology has emerged as a promising solution for continuous NOx decomposition under ultraviolet (UV) irradiation. This study developed an eco-friendly permeable concrete incorporating activated loess and zeolite to improve roadside air quality. The high porosity and adsorption capability of the concrete provided a suitable substrate for a TiO2-based photocatalytic coating. A single-component coating system was optimized by introducing colloidal silica to enhance TiO2 particle dispersibility and adding a binder to secure durable adhesion on the concrete surface. The produced permeable concrete met sidewalk quality standards specified in SPS-F-KSPIC-001-2006. Photocatalytic NOx removal performance evaluated by ISO 22197-1 showed a maximum removal efficiency of 77.5%. Even after 300 h of accelerated weathering, the activity loss remained within 13.8%, retaining approximately 80% of the initial performance. Additionally, outdoor mock-up testing under natural light confirmed NOx concentration removal and formation of nitrate by-products, demonstrating practical applicability in real environments. Overall, the integration of permeable concrete and a durable, single-component TiO2 photocatalytic coating provides a promising approach to simultaneously enhance pavement sustainability and reduce urban NOx pollution.
Amine-functionalized solid adsorbents are widely recognized as promising candidates for direct air capture of CO2; however, their practical deployment remains constrained by humidity-dependent adsorption behavior and poor packed-bed operability arising from irregular particle morphology and fines generation. Rather than focusing solely on maximizing intrinsic adsorption capacity, this study addresses these process-level limitations through an integrated design strategy combining particle morphology control with surface chemistry optimization. Uniform spherical magnesium silicate particles with a mean diameter of approximately 15 μm were synthesized via a water-in-oil emulsion route to suppress fines formation and reduce hydrodynamic resistance. Controlled acid pretreatment was subsequently applied to adjust surface hydroxyl accessibility and enable efficient amine grafting without altering bulk composition. The optimized spherical magnesium silicate amine adsorbents exhibited pronounced humidity-enhanced carbon dioxide capture, achieving capacities of 1.7 to 1.8 millimoles/g at 50% relative humidity, representing an approximately fourfold increase compared with dry conditions. This enhancement is attributed to a humidity-induced mechanistic transition from carbamate formation under dry conditions to water-assisted bicarbonate formation under humid conditions. Complete regeneration was achieved at 100 °C, with stable adsorption desorption behavior maintained over ten consecutive cycles, demonstrating short-term reversibility. These findings highlight morphology controlled scalability. Future work should prioritize durability beyond 100 cycles, mechanical robustness, and techno-economic viability at scale.