This study utilized oscillating laser cladding technology to fabricate nickel-based composite coatings, systematically investigating the influence of varying laser powers on their morphology, microstructure, and properties. The results indicate that as laser power increases from 800 W to 1400 W, the dilution rate of the coating exhibits a non-monotonic change, reaching a maximum at an intermediate laser power due to the competing effects of enhanced substrate melting and melt-pool instability. The microstructure of the coatings is primarily composed of dendritic and equiaxed crystals. Elemental analysis revealed that Ni is predominantly enriched within the dendritic regions, whereas Cr segregates toward the grain boundary areas. Furthermore, the microhardness of the coating, as well as its anti-wear and anti-corrosion properties, are positively correlated with the laser power. When the power reaches the maximum value of 1400 W studied, the performance of the coating significantly improves. The average hardness is 482 HV, and the relative wear resistance is approximately 1.8 times that of the coating when the power is 800 W. The corrosion current density is 9.04 × 10⁻⁷ A/cm².

As high-end equipment manufacturing advances, demand for improved surface performance in critical components has increased. Laser cladding is an advanced surface strengthening technique that affords effective surface modification. During the laser cladding process, obtaining a fine grain microstructure usually helps to enhance the microhardness, wear resistance, and corrosion resistance of the cladding layer. However, conventional laser cladding often yields coarse columnar grains that limit further performance improvements, so process optimization to achieve grain refinement is necessary. In this study, oscillating laser cladding was combined with a pulsed-wave (PW) laser mode to deposit a fine-grained Al₂CrFe₂Ni₄Ti_1.5 high-entropy alloy cladding on Q550 steel substrates. Compared with continuous-wave (CW) laser cladding, the PW mode produced markedly refined grains and concomitant improvements in microhardness, wear resistance, and corrosion resistance. Specifically, the microhardness of the PW cladding layer reached approximately 673.34 HV_0.5, the wear volume was approximately 0.06 mm³, the wear rate was approximately 0.21 × 10⁻⁴ mm³/N·m, and the corrosion current density decreased to approximately 1.212 × 10⁻⁵ A·cm⁻². This work presents a novel approach for producing high-performance, wear-resistant, and corrosion-resistant high-entropy alloy cladding layers, and offers both theoretical insight and potential engineering applications.

This study introduces a novel type of oscillating laser directed energy deposition (OL-DED) technology aimed at improving microstructure uniformity and enhancing wear resistance. The microstructure and wear resistance of the OL-DED coating were analyzed and compared with those of the traditional non-oscillating laser directed energy deposition (TL-DED) coating. The results indicate that the OL-DED coating exhibits superior performance, and the grain size of the OL-DED coating is significantly smaller than that of the TL-DED coating. Furthermore, the wear resistance of the OL-DED coating at room temperature and high temperatures exceeds that of the traditional TL-DED coating. The wear mechanisms at room temperature are primarily characterized by abrasive wear, adhesive wear, and oxidative wear, whereas those at high temperatures are mainly dominated by abrasive wear and oxidative wear, with a slight contribution from adhesive wear.