In geophysical exploration, laser remote sensing detection of seismic waves based on wavefront sensors can be used for geological detection and geophysical exploration. However, due to the high sensitivity of the wavefront sensor, it is easy to be affected by the environmental light and vibration, resulting in random noise, which is difficult to predict, thus significantly reducing the quality of the vibration signal and the detection accuracy. In this paper, a large amount of data is collected through a single-point vibration detection experiment, and the relationship between amplitude and spot centroid offset is analyzed and calculated. The real noisy vibration signal is denoised and signal enhanced by using a BiLSTM denoising convolutional self-encoder (BiL-DCAE). The irregular and unpredictable noise generated by various complex noise mixing is successfully suppressed, and its impact on the vibration signal is reduced. The signal-to-noise ratio of the signal is increased by 13.90 dB on average, and the noise power is reduced by 95.93%, which greatly improves the detection accuracy.
Manufacturing errors introduce phase deviations in Mach–Zehnder interferometers (MZIs) that degrade the fidelity of optical processors. To address this issue, we employ a Broyden–Fletcher–Goldfarb–Shanno (BFGS) quasi-Newton method for phase calibration of a reconfigurable MZI optical processor based on the Reck architecture. By optimizing the mapping from the target matrix to the optical network, the method determines the optimized phase parameters of 12 phase shifters. Thermo-optic simulations are further used to establish the relationship between the applied bias voltage and the induced phase shift, providing a link between the optimized phase parameters and the electrical driving conditions. Compared with Particle Swarm Optimization (PSO), Genetic Algorithms (GA), and Gradient Descent with Momentum (GDM), the BFGS method provides faster convergence and high calibration fidelity. These results demonstrate an efficient approach for phase calibration of programmable MZI optical processors.
Seismic wave analysis is crucial for identifying subsurface formations and geological hazards. In this study, a seismic wave laser remote sensing system based on a Shack–Hartmann wavefront sensor was established by exploiting its high spatial resolution, array-based detection capability, and independent microlens spot centroid measurement. This method was employed to analyze the correlation characteristics among vibration-related physical variables. Experiments were conducted to assess the quantitative correlation between vibration amplitude and spot centroid shift by the Shack–Hartmann wavefront sensor across a range of 0.06–5.94 mm. Accordingly, based on the measured centroid shift, vibration velocity was derived and validated through comparison with reference vibrometer measurements. In addition, the correlation between vibration amplitude and vibration velocity was systematically analyzed. The experimental results demonstrate strong linear correlation between amplitude and both spot centroid shift and vibration velocity, with coefficients of determination exceeding 0.98. The vibration velocity obtained by the proposed system shows strong agreement with vibrometer data, confirming its effectiveness for low-frequency vibration detection. Measurement accuracy can be further improved by reducing noise. These results indicate that the proposed approach provides a promising laser remote sensing solution for seismic wave detection.