Semiconducting thin films of p-ZnIn2Se4 were deposited on a crystalline n-silicon (Si) substrate by a flash evaporation technique. A heterojunction diode comprising of Au/p-ZnIn2Se4/n-Si/Al structure was fabricated. The heterojunction was subjected to current (I)–voltage (V) and capacitance (C)–voltage (V) characterization. The p-ZnIn2Se4/n-Si heterojunction showed behaviour typical of a p-n junction diode. The heterojunction diode ideality factor, rectification ratio, barrier height and carrier concentration were determined from the I–V and C–V measurements. At lower applied voltages, the electrical conduction was found to take place by thermionic emission whereas at higher voltages, a space charge-limited conduction mechanism was observed. A theoretical energy band diagram was constructed for the fabricated p-ZnIn2Se4/n-Si heterojunction on the basis of Anderson’s model. The photovoltaic behaviour of the fabricated heterojunction was also investigated and the results were reported.
In this study, through the utilization of the sol–gel combustion tactic, gadolinium (Gd)-doped cerium oxide (CeO2), Ce1−xGdxO2 (x = 0.00, 0.10, 0.20 and 0.30 (GDC)) ceramics were attained.
ZnIn2Se4 thin films were deposited by flash evaporation of bulk material onto glass and pyrographite substrates under vacuum. The surface aspects of films have been studied by scanning electron microscopy. The dynamic and static current ( I) versus voltage ( V) characteristics of brass/pyrographite/ZnIn2Se4 thin film/platinum sandwiched devices for different film thicknesses (350–650 nm) and temperatures (313–353 K) were measured. The OFF state I–V characteristics of fabricated thin film devices indicated that the conduction mechanism is of the Poole–Frenkel type. In addition, a threshold memory switching mechanism from a high resistance OFF state to a low resistance ON state was observed in these thin film structures. The I–V characteristics of the memory device were studied at different annealed and ambient temperatures. The threshold voltage was found to increase linearly with film thickness and decrease exponentially with ambient temperature. The results obtained were discussed, and a thermal model for initiating the switching process in this device system could be indicated.
21 June 2024 in Journal of Materials Science: Materials in Electronics