Wide-area maritime surveillance is an increasingly important focus for countries with large Exclusive Economic Zones (EEZ), such as Portugal, which are responsible for monitoring and protecting these zones and their resources. Passive acoustic autonomous buoy networks equipped with hydrophones are a promising approach for wide-area maritime surveillance. However, achieving a discrete, low-cost system introduces many technical challenges. This work describes a practical, low-power, two-state architecture that separates continuous ship detection from detailed vessel class classification. First, an always-on microcontroller performs continuous binary ship presence detection and triggers the higher-power classifier only when a vessel is detected. The high-accuracy acoustic classifier was tested across embedded controllers to identify the minimum platform capable of sustaining its intended 1 Hz classification rate. A Raspberry Pi 5 achieved the 1 s target with a measured continuous consumption of 4 W; however, adding sensing, storage, and communications is expected to raise the always-on consumption to around 5 W. If this node was used by itself, a week-long autonomy requirement, therefore, would imply 840 Wh of usable energy storage, and recovering this deficit rapidly under limited insolation would require several hundred watts of photovoltaic capacity, driving both buoy volume and cost up. To address this, an always-on edge node based on an ESP32-S3 microcontroller was implemented, running a lightweight binary detection of a vessel presence model trained in Edge Impulse using a subset of Ocean Networks Canada recordings. The edge node consumes W continuously and is intended to trigger a wake-up line to power the higher-performance node only when a ship is detected, reducing average energy demand while maintaining the ability to run a richer classifier on demand. The presented architecture, profiling workflow, and energy calculations provide a path to power-aware passive acoustic monitoring systems suitable for extended maritime deployments.
27 February 2026 in Journal of the European Optical Society-Rapid Publications
Technological advances in global communications depend significantly on robust and efficient long-distance infrastructures. One notable example is the submarine cable network. Installed on the ocean floor, these cables use fiber optic technology to transmit large volumes of data at high speed and low latency between continents. Beyond their primary communication function, recent innovations allow these cables to serve as Distributed Acoustic Sensing (DAS) systems, effectively converting tens of kilometers of passive fiber into massive, coherent arrays of vibration sensors. The primary objective of this project is to enhance maritime surveillance capabilities by integrating DAS technology with advanced kinematic modeling. This paper establishes a rigorous physical and mathematical framework for interpreting the acoustic signatures of surface vessels detected by bottom-mounted fibers. We derive the complete opto-acoustic transfer function, formulate the hyperbolic moveout equations based on a moving point-source solution to the wave equation, and implement a stochastic inversion scheme using Differential Evolution. By optimizing a correlation-based loss function, we demonstrate the ability to recover vessel trajectory, speed, and depth from complex interferometric patterns with speed estimation errors consistently below 1%. This approach allows for the extraction of quantitative physical parameters from raw optical data, bridging the gap between photonics and hydroacoustics.
Distributed Acoustic Sensing (DAS) leverages the sensitivity of optical fibers to detect environmental vibrations. This study demonstrates the capability of DAS to identify and characterize the acoustic signatures of passing vessels, highlighting its potential to enhance maritime surveillance and monitoring.