Curvature measurement plays an important role in many fields. Aiming to overcome shortcomings of the existing optical fiber curvature sensors, such as complicated structure and difficulty in eliminating temperature noise, we proposed and demonstrated a simple optical fiber curvature sensor based on surface plasmon resonance. By etching cladding of the step-index multimode fiber and plating gold film on the bare core, the typical Kretschmann configuration is implemented on fiber, which is used as the bending-sensitive region. With increases in the curvature of the optical fiber, the resonance wavelength of the SPR (Surface Plasmon Resonance) dip linear red-shifts while the transmittance decreases linearly. In the curvature range between 0 and 9.17 m⁻¹, the wavelength sensitivity reached 1.50 nm/m⁻¹ and the intensity sensitivity reached −3.66%/m⁻¹. In addition, with increases in the ambient temperature, the resonance wavelength of the SPR dips linearly blueshifts while the transmittance increases linearly. In the temperature range between 20 and 60 °C, the wavelength sensitivity is −0.255 nm/°C and the intensity sensitivity is 0.099%/°C. The sensing matrix is built up by combining the aforementioned four sensitivities. By means of the dual modulation method, the cross-interference caused by temperature change is eliminated. Additionally, simultaneous measurement of curvature and temperature is realized.

Micro-displacement measurements play a crucial role in many industrial applications. Aiming to address the defects of existing optical-fiber displacement sensors, such as low sensitivity and temperature interference, we propose and demonstrate a novel surface plasmon resonance (SPR)-based optical-fiber micro-displacement sensor with temperature compensation. The sensor consists of a displacement-sensing region (DSR) and a temperature-sensing region (TSR). We employed a graded-index multimode fiber (GI-MMF) to fabricate the DSR and a hetero-core structure fiber to fabricate the TSR. For the DSR, we employed a single-mode fiber (SMF) to change the radial position of the incident beam as displacement. The resonance angle in the DSR is highly sensitive to displacement; thus, the resonance wavelength of the DSR shifts. For the TSR, we employed polydimethylsiloxane (PDMS) as a temperature-sensitive medium, whose refractive index is highly sensitive to temperature; thus, the resonance wavelength of the TSR shifts. The displacement and temperature detection ranges are 0–25 μm and 20–60 °C; the displacement and temperature sensitivities of the DSR are 4.24 nm/μm and −0.19 nm/°C, and those of the TSR are 0.46 nm/μm and −2.485 nm/°C, respectively. Finally, by means of a sensing matrix, the temperature compensation was realized.