Timothy J Langan

Dr. Timothy J Langan


Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
29 December 2023
Verified
Book Chapter
Closed access
PDF file
TLTimothy J Langan
Timothy J Langan
TDThomas Dorin
Thomas Dorin

3 February 2024
Verified
Book Chapter
Closed access
PDF file
ASAvishan Shomali
Avishan Shomali
TLTimothy J Langan
Timothy J Langan
TWThomas Wood
Thomas Wood
PSPaul Sanders
Paul Sanders

Eli HarmaEli Harma
Eli Harma
PSPaul Sanders
Paul Sanders
TWThomas Wood
Thomas Wood
TLTimothy J Langan
Timothy J Langan
There is a demand for a 6005A series extrusion alloy with improved strength that maintains good extrudability. Replacing Mn and Cr dispersoid formers with Sc and Zr is expected to increase the room temperature mechanical properties while not affecting extrudability. Al3X dispersoids with a Sc core surrounded by a Zr shell are stable at higher temperatures and enhance recrystallization resistance and precipitation strengthening. However, there is little information on how the Sc and Zr additions affect the properties of an extrudate as a function of extrusion geometry and ratio. A 6005A series alloy with Cr and Mn additions is compared to an alloy with Sc and Zr additions with rod and flat cross-sections at extrusion ratios of 25 and 92. The results show that Sc and Zr additions increased yield strength and ultimate tensile strength while maintaining ductility compared to Cr and Mn additions. Rod shapes performed significantly better than flat shapes, but there was no significant effect of extrusion ratio.

Verified
Journal Article
Open access
PDF file
Eli HarmaEli Harma
Eli Harma
TLTimothy J Langan
Timothy J Langan
PSPaul Sanders
Paul Sanders
Adding Sc to 6xxx series alloys has led to inconsistent results due to the formation of the high-temperature, thermodynamically stable V-phase (AlSc2Si2). Thermo-Calc single-axis equilibrium and phase diagram calculations were employed to identify V-phase formation with varying Si and Zr concentrations, indicating that increasing Zr and decreasing Si lowered the V-phase equilibrium volume fraction. Increasing Zr also shifted the V-phase equilibrium to higher Si concentrations. To access real-world influences of Zr and Si, four compositions were cast with different Si and Zr concentrations: a high-Si, low-Zr alloy; a medium-Si, medium-Zr alloy; a low-Si, high-Zr alloy; and a baseline alloy without Zr and Sc. The compositions were DC-cast followed by multi-step isochronal and isothermal heat treatments, which revealed that increasing Zr concentration did not influence the formation of V-phase but did result in higher hardness at high temperatures, likely due to Al3Zr precipitation. In contrast, higher Si and lower Zr concentrations produced higher hardness in the peak-aged condition but lower hardness at homogenization temperatures in the 400 °C to 520 °C range. Given these conclusions, a new alloy and a multi-step homogenization process are proposed to further develop Sc- and Zr-containing 6xxx extrusion alloys.