Dynamic mechanical analysis (DMA) is the usual technology for the thermomechanical viscoelastic characterization of materials. This method monitors the instant values of load and displacement to determine the instant specimen stiffness. Posteriorly, it recurs to those values, the geometric dimensions of the specimen, and Poisson’s ratio to determine the complex modulus. However, during this analysis, it is assumed that Poisson’s ratio is constant, which is not always true, especially in situations where the temperature can change and promote internal modification in the specimens. This study explores the error that is imposed in the results by the determination of the real values of complex moduli due to variable Poisson’s ratios arising from temperature variability using a constant frequency. The results suggest that the evolution of the dynamic mechanical analysis should consider the Poisson’s ratio input as a variable to eliminate this error in future material characterization.
New alloy processes have been developed and casting techniques are continuously evolving. Such constant development implies a consequent development and optimization of melt processing and treatment. The present work proposes a method for studying the influence of acoustic pressure in the overall refinement of sand cast aluminum alloys, using and correlating experimental and numerical approaches. It is shown that the refinement/modification of the α-Al matrix is a consequence of the acoustic activation caused in the liquid metal directly below the face of the acoustic radiator. Near the feeder, there is a clear homogeneity in the morphology of the α-Al with respect to grain size and grain circularity. However, the damping of acoustic pressure as the melt is moved away from the feeder increases and the influence of ultrasound is reduced, even though the higher cooling rate seems to compensate for this effect.
25 September 2016 in Proceedings of the Institution of Mechanical Engineers, Part L: Journal of Materials: Design and Applications
Lightweight metallic lattices in the form of honeycombs are long known to exhibit a good mechanical strength/weight relation, given their geometry and relative density, in comparison with bulk materials. Due to the current developments in additive manufacturing techniques, the production of honeycombs by investment casting is now easier and may be a competitive route when compared to welding and gluing of sheet metal. This study explores the importance of the manufacturing design when producing honeycombs by investment casting. It is shown by numerical simulation and experimental procedures that mold filling in directions where horizontal ribs are present may induce defects such as interdendritic porosities. These defects have a relevant role in the elastic domain of the lattices, decreasing the apparent Young’s modulus and the plastic collapse stress. In terms of energy absorption, it is shown that these porosities have no significant effect due to the fragile fracture of both casting directions.
In this paper, low-cost, aluminum-based composite metal foams are produced by the gravity die casting technique using lightweight expanded clay (LECA) as space holders. The influence of the voids generated by LECA particles on the syntactic composite samples density and mechanical behavior is characterized by quasi-static uniaxial compression. It is shown that smaller particles generate higher relative densities and a reduction in the value of densification strain. The use of larger particle diameter promotes an increase in yield strength and a more stable plateau region of the stress–strain curve, leading to higher values of crushing energy absorption. The influence of the internal structure on these experimental results is correlated with elasto-plastic numerical simulations, and it is suggested that a small mismatch in LECA particle diameter is advantageous for enhancing mechanical properties.