The thermal properties of pavement layers made of concrete with varying bulk densities are a particularly interesting topic in the context of development road technologies. If a hybrid layer system is used as a starting point, with thin asphalt layers (from 1 cm to 4 cm) laid on top of a foam concrete layer, thermal properties begin to play a crucial role. The main research problem was to create a test method enabling the assessment of the influence of solar heating on the thermal parameters of the building material, especially cement concrete. For this reason, this paper is concerned specifically with the assessment of a new methodology for testing and calculating the value of the thermal diffusivity coefficient of samples made of concrete varying bulk densities. In this case, using the proprietary concept the authors built a solar simulator using a multi-source lighting system. The analysis of the results of laboratory tests and numerical analyses allowed the authors to observe that there is a strong correlation between the bulk density of samples heated and the thermal diffusivity parameter, which appears in the unidirectional heat transfer equation. The strength of this relationship has been expressed with the coefficient of determination and amounts to 99%. The calculated values of the coefficient of thermal diffusivity for samples made of foam concrete range from to and are lower (from 2.5 to 8 times) than the value determined for samples made of typical cement concrete.
This article examines the potential risk of impaired visibility for drivers caused by sunlight reflecting off the surfaces of PV panels installed within the right-of-way of motorways and expressways. A literature review was conducted to describe the current state of knowledge and identify the requirements applicable to this area. The procedures for measuring the reflective properties of PV panels using a goniophotometer and a luminance camera (imaging luminance measuring device—ILMD) were evaluated. The measurement results for three PV panels with different surface structures are presented, allowing the properties of PV panels to be determined in terms of their potential impact on driver safety. A computer application was developed to determine whether the sun’s rays will reflect off a photovoltaic panel’s surface toward a vehicle’s direction of travel. The application graphically displays information on whether the sun will be reflected in the direction of a moving vehicle and whether this reflection poses a threat to driver safety. A comprehensive procedure for assessing the risk of glare caused by sunlight reflecting off the surfaces of photovoltaic panels was developed, along with detailed requirements. This study supports sustainable development by promoting renewable energy deployment in motorway corridors while simultaneously ensuring road safety. It integrates environmental (renewable energy use), social (driver safety), and technical (quantitative glare assessment methods) dimensions of sustainability.