Chalcostibite (CuSbS2) is composed of earth-abundant elements and has a proper band gap (Eg = 1.05 eV) as a thermoelectric (TE) material. Herein, we report the TE properties in the CuSbS2based composites with a mole ratio of (1−x)CuSbS2−xCu18S (x = 0, 0.1, 0.2, 0.3), which were prepared by mechanical alloying (MA) combined with spark plasma sintering (SPS). X-ray diffraction (XRD) and back-scattered electron image (BSE) results indicate that a single phase of CuSbS2 is synthesized at x = 0 and the samples consist of CuSbS2, Cu3SbS4, and Cu12Sb4S13 at 0.1 ⩽ x ⩽ 0.3. The correlation between the phase structure, microstructure, and TE transport properties of the bulk samples is established. The electrical conductivity increases from 0.14 to 50.66 S·cm−1 at 723 K and at 0 ⩽ x ⩽ 0.03, while the Seebeck coefficient holds an appropriate value of 190.51 µV·K−1. The highest ZT value of 0.17 is obtained at 723 K and at x = 0.3 owing to the combination of a high PF 183 µW·m−1·K−2 and a low κ 0.8 W·m−1·K−1.
In this paper, copper–graphene composites were fabricated by using two different processing routes (ball milling (BM) and ultrasonication) followed by spark plasma sintering. Vickers hardness and anisotropic thermal conductivity of the composites were measured and observed that ultrasonicated fabricated composites gave better result compared with BM composite and even from pure copper. The hardness values obtained for ultrasonicated copper–graphene composite were 69 HV (57% higher) and thermal conductivity 387 W/m K (13% higher) by using only 0.5 wt-% of graphene, while for pure copper the values were 44 HV and 341 W/m K. The value of anisotropic thermal conductivity ultrasonicated composites was also 1.97 which is much higher than pure copper 0.94.