The applicability of the typical pressure–sinkage models used to characterize the soil’s bearing properties is limited to homogeneous soils (infinite thickness) that have no hard layer. At a given depth, a hard layer can have a considerable impact on the soil’s load-bearing capacity. It is thus necessary to alter the pressure–sinkage equation by taking this condition into account when assessing the load-bearing capacity. The present paper aims to determine a simple, high-fidelity model, in terms of soil characterization, that can account for the hard layer affection. To assess hard layer affection in this paper, a plate sinkage test (bevameter) was conducted on sandy loam soil. To this end, the soil was prepared by considering three bulk densities and two soil thickness levels at 7–9% moisture content levels. According to the results, this paper put forth a new perspective and related equations for characterizing bearing performance. The sinkage modulus (k) is an intrinsic soil parameter that has a determined unit of N/cm2 and is significant for managing the bearing performance. The results showed that the new modulus sinkage model incorporates the main factor of the rigid layer effect involving high fidelity that the conventional models have failed to account for.
The stability of vehicles is one of the most important factors of safety. When assessing the conditions for the stability of the vehicle, on-road and off-road vehicles differ in many aspects, and because of this, specific methods are needed to describe the stability conditions for terrain vehicles. In this paper, the aspects of off-road vehicle stability are assessed, and terrain vehicle-specific stability modeling methods are shown. After that, LiDAR-based terrain mapping technology and the measurement and remote sensing possibilities for the variables affecting stability, both from the vehicle and terrain, are introduced. Field measurements conducted with a small-scale remote-controlled vehicle are presented, the measured and model-predicted stability values are compared, and it is concluded that the theoretical model does describe the actual values accurately enough that the differences can be mitigated by introducing a safety factor. At the end, some further possibilities are proposed for the improvement of the stability modeling method.
This study examines the confined compression behavior of soils with varying clay content under controlled boundary conditions. A carefully designed experimental setup was utilized, maintaining constant parameters including the soil thickness-to-plate diameter ratio (H/D), initial bulk density (ρ), and plate diameter (D). This controlled framework enabled the isolated investigation of the effects of clay content on soil compression behavior. A systematic range of soil textures, characterized by increasing clay content, was tested to observe trends and establish relationships between clay content and confined compression response. The evaluation involved the calculation of key parameters relevant to terrain–vehicle systems, such as the load-bearing capacity factor (k) and vertical soil pressure (p). By analyzing the variation in these parameters in relation to clay content, the study aims to clarify how clay proportion and associated soil characteristics, such as plasticity and cohesion, affect load-bearing capacity under confined conditions. Furthermore, the influence of moisture content on the load-bearing capacity factor was investigated within the same boundary conditions, providing additional insight into the interaction between moisture, clay content, and soil strength. The findings of this research will enhance the understanding of soil mechanical behavior under confined compression, with particular relevance to terrain–vehicle interactions and the optimization of off-road mobility.
Stability of vehicles is one of the most important factors of safety. When assessing the conditions for the stability of the vehicle, on-road and off road vehicles differ in many perspectives, and because this, specific methods are needed to describe the stability conditions for terrain vehicles. In this paper, the aspects of off-road vehicle stability are assessed, terrain vehicle specific stability modeling methods are shown. After that, the LiDAR based terrain mapping technology and the measurement and remote sensing possibilities for the variables affecting the stability, both from the side of the vehicle and terrain, are introduced. At the end, field measurements conducted with a small scale remote controlled vehicle are presented.