Permanent injury to corneal limbal stem cells after ocular surface chemical and thermal injuries is a major cause of corneal blindness. In this study, a PRP‐laden GelMA hydrogel contact lens is manufactured which is aimed to support the limbal niche after ocular surface insults thereby preventing limbal stem cell failure. GelMA with varying platelet‐rich plasma (PRP) concentrations (5%, 10%, and 20%) is photopolymerized using a visible light crosslinking system followed by characterizations of mechanical properties, growth factor release, enzymatic degradation, and in vitro cytotoxicity. The addition of 10% PRP into 10% GelMA hydrogel precursor solution results in the highest tensile and compressive modulus (38 and 110 kPa, respectively) and burst pressure (251±37.66 mmHg). Degradation time varies according to the concentration of the collagenase enzyme tested (0, 2.5, 5, and 40 µg/mL) and is most prolonged with 20% PRP. EGF and TGF‐β release profiles suggest an initial burst release followed by sustained release, most consistent in the 10% PRP sample. Although cell viability decreases on day 1, rapid recovery is observed and is approximately 120% after day 21. PRP‐laden GelMA in the form of a contact lens may be a promising biomaterial‐based treatment approach for the maintenance of limbal epithelial stem cells after ocular surface insults.
The complex process behind the brain topology, which has been extensively studied for the last ten years, is still unclear. Therefore, neural tissue engineering studies are needed to better understand cortical folds. With the development of 4-dimensional (4D) bioprinters using cell-loaded smart materials, a promising path has been opened in the mimicry of the neural tissue. In our study, we review the usage areas of 4D printers, which have been developing in recent years, in modelling brain tissue. As a result of development of smart materials printed with 3-dimensional (3D) printers caused emerging of 4D printers, rapidly. Smart materials can change their properties based on physical, chemical and biological stimuli, and this change can be a reversible process. Cell-loaded printed smart materials should have little effect on cell viability of both the incoming stimulus and the physical change. It is also important that the material used is non-toxic and the solvent is suitable for cell viability. On the other hand, hydrogels are frequently studied to mimic the complex neural network of neural tissue. Agents that affect the crosslinking or degree of crosslinking of hydrogels can be easily controlled and changed. In addition, studies with neural stem cells have shown that hydrogels have a supportive effect on the proliferation and maturation of neural stem cells. Since the folding time, strength and location of smart materials cannot be known precisely, it can be an advantage of 4D bioprinters as it can be controlled and studied whether the results of the stress on the cells in this region will affect other cells. It is an ideal methodology to study the effect of cortical folding on neural stem cells, especially thanks to the ease of experimental manipulations provided by 4D bioprinters. It is expected that 4D bioprinters will be adopted and rapid developments will occur in the multidisciplinary field of tissue engineering of brain tissue in the near coming years.