Hasan Alkhatib

Hasan Alkhatib

orcid

Research Focus & Metrics

Academic Career Length

2Years (2025-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
3 April 2026 in Energies
Verified
Journal Article
Open access
PDF file
PPPavlo Perkhun
Pavlo Perkhun
AKAnass Khodr
Anass Khodr
YQYatzil Alejandra Avalos Quiroz
Yatzil Alejandra Avalos Quiroz
AKAral Karahan
Aral Karahan
HAHasan Alkhatib
Hasan Alkhatib
JAJörg Ackermann
Jörg Ackermann
Thick-film organic photovoltaics (OPVs) are key for scalable manufacturing, but increasing active-layer thickness usually lowers power conversion efficiency (PCE) due to charge recombination and limited carrier extraction. We report high-efficiency thick-film OPVs fully processed in air by doctor blading using non-halogenated solvents (o-xylene with 3.5% tetralin) for two non-fullerene acceptor systems: PM6:ITIC-4F and PTQ-10:ITIC-4F. Active layers (100–500 nm) were fabricated by adjusting the coating speed while keeping the ink concentration and gap constant. Under mild drying (40 °C, 2 min), both systems exhibited significant efficiency losses at 1 sun (AM1.5G) as the thickness increased, whereas performance was largely preserved under indoor LED illumination (200 lx and 1000 lx), enabling high performance for thick films. Short thermal post-annealing (80–140 °C, 2 min) further improved PCE by reducing bimolecular recombination and enhancing nanostructure. Optimized PM6:ITIC-4F devices reached 10.2% (300 nm) under 1 sun and 14.78% at 200 lx; PTQ-10:ITIC-4F achieved 11.3% (500 nm) under 1 sun and up to 15.71% at 200 lx. Morphological and structural analysis indicates that the superior thick-film performance of PTQ-10:ITIC-4F is linked to favorable phase behavior, polymer-rich surface composition, and preferential face-on molecular orientation, promoting charge collection. These results demonstrate that low-cost PTQ-10 and non-halogenated air processing can enable industrially relevant, high-performance thick-film OPVs.

28 April 2025 in Journal of Lightwave Technology
Verified
Journal Article
Closed access
LBLisa Bouby
Lisa Bouby
GCGilles Chabriel
Gilles Chabriel
JBJean Barrere
Jean Barrere
SDSadok Ben Dkhil
Sadok Ben Dkhil
MPMarie Parmentier
Marie Parmentier
JSJean-Jacques Simon
Jean-Jacques Simon
The frequency response of a photovoltaic photodetector to LED light intensity modulations is used to measure its performance as a data receiver for indoor visible light communication. An equivalent small-signal active model consistent with this dynamic response would help in understanding how the core materials and interfaces within the photovoltaic device influence the overall behavior. This paper presents a new approach to modeling the dynamic behavior of a photovoltaic device by jointly utilizing its spectral response to electrical excitation (known as Electrical Impedance Spectroscopy) and photonic excitation (known as Intensity Modulated Photocurrent Spectroscopy). To minimize the time required for measurements and ensure the stability of experimental conditions we use orthogonal frequency division multiplexing input signals. Preliminary results obtained with a monocrystalline silicon photovoltaic cell and an organic photovoltaic cell demonstrate the relevance of our approach.