The low-temperature thermoelectric performance of Bi-rich n-type Mg3(Bi,Sb)2 was limited by the electron transport scattering at grain boundaries, while removing grain boundaries and bulk crystal growth of Mg-based Zintl phases are challenging due to the volatilities of elemental reactants and their severe corrosions to crucibles at elevated temperatures. Herein, for the first time, we reported a facile growth of coarse-grained Mg3Bi2-xSbx crystals with an average grain size of ~800 μm, leading to a high carrier mobility of 210 cm2 · V−1 · s−1 and a high z of 2.9 × 10−3 K−1 at 300 K. A $$\Delta$$ T of 68 K at Th of 300 K, and a power generation efficiency of 5.8% below 450 K have been demonstrated for Mg3Bi1.5Sb0.5- and Mg3Bi1.25Sb0.75-based thermoelectric modules, respectively, which represent the cutting-edge advances in the near-room temperature thermoelectrics. In addition, the developed grain growth approach can be potentially extended to broad Zintl phases and other Mg-based alloys and compounds.
Charge-trapping memory with high-κ insulator films is a candidate for future memory devices. Many efforts with different indirect methods have been made to confirm the trapping position of the charges, but the reported results in the literatures are contrary, from the bottom to the top of the trapping layers. Here we characterize the local charge distribution in the high-κ dielectric stacks under different bias with in situ electron holography. The retrieved phase change induced by external bias strength is visualized with high spatial resolution and the negative charges aggregated on the interface between Al2O3 block layer and HfO2 trapping layer are confirmed. Moreover, the positive charges are discovered near the interface between HfO2 and SiO2 films, which may have an impact on the performance of the charge-trapping memory but were neglected in previous models and theory.
5 December 2016 in Proceedings of the National Academy of Sciences
Emerging classes of concentrator photovoltaic (CPV) modules reach efficiencies that are far greater than those of even the highest performance flat-plate PV technologies, with architectures that have the potential to provide the lowest cost of energy in locations with high direct normal irradiance (DNI). A disadvantage is their inability to effectively use diffuse sunlight, thereby constraining widespread geographic deployment and limiting performance even under the most favorable DNI conditions. This study introduces a module design that integrates capabilities in flat-plate PV directly with the most sophisticated CPV technologies, for capture of both direct and diffuse sunlight, thereby achieving efficiency in PV conversion of the global solar radiation. Specific examples of this scheme exploit commodity silicon (Si) cells integrated with two different CPV module designs, where they capture light that is not efficiently directed by the concentrator optics onto large-scale arrays of miniature multijunction (MJ) solar cells that use advanced III–V semiconductor technologies. In this CPV+ scheme (“+” denotes the addition of diffuse collector), the Si and MJ cells operate independently on indirect and direct solar radiation, respectively. On-sun experimental studies of CPV+ modules at latitudes of 35.9886° N (Durham, NC), 40.1125° N (Bondville, IL), and 38.9072° N (Washington, DC) show improvements in absolute module efficiencies of between 1.02% and 8.45% over values obtained using otherwise similar CPV modules, depending on weather conditions. These concepts have the potential to expand the geographic reach and improve the cost-effectiveness of the highest efficiency forms of PV power generation. Significance Concentrator photovoltaic (CPV) systems, wherein light focuses onto multijunction solar cells, offer the highest efficiencies in converting sunlight to electricity. The performance is intrinsically limited, however, by an inability to capture diffuse illumination, due to narrow acceptance angles of the concentrator optics. Here we demonstrate concepts where flat-plate solar cells mount onto the backplanes of the most sophisticated CPV modules to yield an additive contribution to the overall output. Outdoor testing results with two different hybrid module designs demonstrate absolute gains in average daily efficiencies of between 1.02% and 8.45% depending on weather conditions. The findings suggest pathways to significant improvements in the efficiencies, with economics that could potentially expand their deployment to a wide range of geographic locations.
The structure, magnetism, and topological transport properties of noncollinear antiferromagnetic hexagonal Mn3Ga magnets have been investigated. Structural analyses reveal that as the temperature decreases, hexagonal Mn3Ga shows a Jahn–Teller-like distortion at T = 120 K. The distortion results in the anisotropy decreasing with decreasing temperature. Positive magnetoresistance is observed, and humps occur at low magnetic fields, which can be understood by breaking the ordered antiferromagnetic configuration by an external field and the spin-dependent scattering mechanism, respectively. In addition, a large topological Hall effect is observed in Mn3Ga, which originates from the noncollinear triangular magnetic configuration with slight distortion. The results are discussed in the context of coupling with noncollinear spin canting, lattice distortion, and topological transport.
We report on the observation of a large negative magnetoresistance (MR) with magnitudes of −67%, −45%, and −31% in antiferromagnetic half-Heusler compounds TbPtBi, HoPtBi, and ErPtBi, respectively. It is found that with increasing temperature, the values of the negative MR vary smoothly and persist well above their Neel temperature TN. Besides the negative MR effects, we have further observed a nontrivial Berry phase (∼π) extracted from Shubnikov–de Haas oscillation in HoPtBi. These results together with band structure calculations unambiguously give evidence of the chiral anomaly effect and are valuable for understanding the Weyl fermions in magnetic lanthanide half-Heusler compounds.