Surface pre-treatment is one of the key processes in bonded repair of aircraft carbon fibre reinforced polymer composites. This paper investigates the surface modification of physical and chemical properties by laser ablation and conventional polish treatment techniques. Surface morphology analysed by laser scanning confocal microscopy and scanning electron microscopy showed that a laser-treated surface displayed higher roughness than that of a polish-treated specimen. The laser-treated laminate exhibited more functional groups in the form of O 1 s/C 1 s atomic ratio of 30.89% for laser-treated and 20.14% for polish-treated as evidenced by X-ray photoelectron spectroscopy observation. Contact angle goniometry demonstrated that laser treatment can provide increased surface free energy and wettability. In the light of mechanical interlocking, molecular bonding and thermodynamics theories on adhesion, laser etching process displayed enhanced bonding performance relative to the polishing surface treatment. These properties resulted in an increased single lap shear strength and a cohesive failure mode for laser etching while an adhesive failure mode occurred in polish-treated specimen.
We report an efficient and green approach to synthesize a linear castor oil-based polyurethane (CPU) without using any solvent or catalyst. Diol monomers were first synthesized by the aminolysis reaction between castor oil and diamines; this was accomplished within 6 h at 130 °C. Polymerization of the diols and isocyanate was further confirmed by Fourier transform infrared (FTIR), 1H-nuclear magnetic resonance (1H-NMR), and gel permeation chromatography analyses. The resultant CPUs showed a good thermal stability with an initial degradation temperature higher than 300 °C, and their mechanical and wood bonding property can be modulated by the structures of diamine. In addition, the CPUs possessed a satisfying water resistance property with the water absorption amount lower than 2%. The green conversion of castor oil to thermoplastic polyurethane affords new opportunities in bio-based industries.
Reliability and controllability of selective removal of multiple paint layers from the surface of aircraft skin depend on effective online monitoring technology. An analysis was performed on the multi-pulse laser-induced breakdown spectroscopy (LIBS) on the surface of the aluminum alloy substrate, primer, and topcoat. Based on that, an exploration was conducted on the changes of the characteristic peaks corresponding to the characteristic elements that are contained in the topcoat, primer, and substrate with different layers of a laser action, in combination with analysis of microscopic morphology, composition, and depth of laser multi-pulse pits. The results show that the appearance and increase of the characteristic peak intensity of the Ca I at the wavelength of 422.7 nm can be regarded as the basis for the complete removal of the topcoat; the decrease or disappearance of the characteristic peak intensity can be regarded as the basis for the complete removal of the primer. Al I spectrum at the wavelength of 394.5 nm and 396.2 nm can be adopted to characterize the degree of damage to the aluminum alloy substrate. The feasibility and accuracy of the LIBS technology for the laser selective paint removal process and effect monitoring of aircraft skin were verified. Demonstrating that under the premise of not damaging the substrate, laser-based layered controlled paint removal (LLCPR) from aircraft skin can be achieved by monitoring the spectrum and composition change law of specified wavelength position corresponding tothe characteristic elements that are contained in the specific paint layer.