Simultaneous wireless information and power transfer (SWIPT) and mobile-edge computing (MEC) are promising technologies in Internet of Things (IoT) era, which can enhance the self-sustainability and computation capability of user equipment (UE), respectively. In this paper, we propose a multiple input multiple output (MIMO) full-duplex (FD) relay based SWIPT-MEC system. With MEC and SWIPT, the UE can use its battery energy to execute computation task locally or offload part or all of it to the access point (AP) connected with a MEC server, and refill the battery while receiving the computation results. FD mode allows the relay to receive and transmit the offloaded bits simultaneously. Based on these, an energy efficient problem is formulated to minimize the system energy consumption over a time block, while the latency constraints and the energy consumption constraints are guaranteed. Since the original problem is non-convex, we use alternating optimization (AO) technique to convert the original problem into three subproblems. And some propositions and algorithms are proposed to solve these three subproblems. Numerical results demonstrate that the proposed optimization scheme achieves a significant performance gain by comparisons with three benchmark schemes.
We consider a multiple-input multiple-output amplify-and-forward wireless multiple-hop sensor network (WMSN). The simultaneous wireless information and power transfer technology is deployed to potentially achieve an autonomous system. We investigate two practical receiver schemes, which are the power splitting (PS) and the time switching (TS). The power splitting receiver splits received signals into two streams, one for information decoding (ID) and the other for energy harvesting (EH). On the other hand, the time switching receiver only serves in ID mode or energy harvesting mode during a certain time slot. Subject to transmit power constraints and destination harvested energy constraint, we aim to obtain a joint beam-forming solution of source and relay precoders to maximize the maximum achievable rate of the WSN. In order to make the non-convex problem tractable, diagonalization-based alternating optimization algorithms are proposed. Numerical results show the convergence and good performance of the proposed algorithms under both PS and TS protocols.
18 May 2018 in Journal of Ambient Intelligence and Humanized Computing
A multi-user multiple-input single-output simultaneous wireless information and power transfer full-duplex system with imperfect channel state information is considered. Under the assumption that the unknown channel estimation error is within a certain range, the self-interference cannot be suppressed completely at the base station and at the multi-user nodes. The proposed design problem is formulated as maximizing the average harvested energy of multi-user nodes and maintaining the signal-to-interference-plus-noise ratio requirement, which is proved to be non-convex. Utilizing semidefinite relaxation and S-procedure methods, a convex optimization problem of optimal beamforming vector for the multi-antenna transmitter is obtained. Moreover, semidefinite relaxation is proved to be tight by showing the existence of rank-one optimal solutions. Simulation results are presented to verify the robustness and effectiveness of the proposed algorithm compared with the non-robust design.
A full-duplex, amplify-and-forward multiple relay system employing simultaneous wireless information and power transfer receivers operating in interference channels is studied. Since all links want to maximize their own achievable rate, a power allocation problem under transmit power and energy harvesting constraints is developed. Through alternative optimization, a distributed iterative water-filling algorithm based on game theory with provable convergence is devised. The existence and uniqueness of a Nash equilibrium point are both guaranteed and the convergence of the proposed algorithm is examined using a diagonally strict concavity condition. Numerical results show that the proposed algorithm is convergent and can achieve a higher sum rate than previous schemes.
15 June 2018 in IEEE Journal of Electromagnetics, RF and Microwaves in Medicine and Biology
In this paper, we consider a magnetic resonance charging system consisting of two transmit coils and two receive coils that is designed to wirelessly charge biomedical wearable diagnostic and therapeutic devices using for ergonomics, rehabilitation and neurology. Since it is proved that the power transfer efficiency will be maximized when the phase difference between the transmit currents equals to zero, an optimization problem is formulated to maximize the received power at both receive coils by adjusting the amplitude of transmit coil currents and the receive coil resistances equipped on wearable devices. The formulated problem is nonconvex and we propose an efficient iterative solution by solving a series of geometric programs that approximate the original problem. Both numerical results and simulation results in COMSOL model are provided to demonstrate the effectiveness of the proposed biomedical wearable system and optimization algorithm.