Mercury intrusion porosimetry (MIP) is questioned for possibly damaging the micro structure of cement-based materials (CBMs), but this theme still has a lack of quantitative evidence. By using X-ray computed tomography (XCT), this study reported an experimental investigation on probing the pore structure damages in paste and mortar samples after a standard MIP test. XCT scans were performed on the samples before and after mercury intrusion. Because of its very high mass attenuation coefficient, mercury can greatly enhance the contrast of XCT images, paving a path to probe the same pores with and without mercury fillings. The paste and mortar showed the different MIP pore size distributions but similar intrusion processes. A grey value inverse for the pores and material skeletons before and after MIP was found. With the features of excellent data reliability and robustness verified by a threshold analysis, the XCT results characterized the surface structure of voids, and diagnosed the pore structure damages in terms of pore volume and size of the paste and mortar samples. The findings of this study deepen the understandings in pore structure damages in CBMs by mercury intrusion, and provide methodological insights in the microstructure characterization of CBMs by XCT.
1 January 2014 in Journal of Zhejiang University-SCIENCE A
The mechanical performance of textile reinforced concrete (TRC) thin-plate under high temperature conditions was investigated using three-point bending tests. The influence of polypropylene (PP) fiber addition on the out-of-plane load capacity of TRC thin-plate after high temperature treatment was also studied. The results showed that the thermostability of TRC thin-plate with textile impregnated with epoxy resin was not good, but that the out-of-plane load capacity of TRC thin-plate after high temperature treatment could be improved by increasing the plate thickness or the textile distribution rate. Under normal temperature and a high temperature of 120 °C, the out-of-plane load capacity of specimens could be increased and cracks better distributed by mixing the TRC with PP fiber. However, the out-of-plane load capacity of TRC thin-plate under a continuous high temperature of 200 °C was not much affected by the addition of PP fiber. The result of a microcosmic scanning electron microscope (SEM) test showed that the main reason for the interfacial adhesive failure between the textile and the original concrete substrate was the degradation of the epoxy resin under high temperature. 探讨不同温度和持续时间对织物增强混凝土(TRC)薄板裂缝行为和承载能力的影响。 通过微观扫描电镜观测观测, 分析纤维编织网与基体混凝土间的界面黏结破坏机理。 明确了高温后纤维编织网与基体混凝土之间界面粘结破坏的主要原因。 以温度和持时为基本参数, 对TRC 构件的耐高温性能进行正确评价。 通过三点弯曲试验(见图3), 对高温后试件的力学性能(见图4、5)进行测试。 通过微观扫描电镜观测(见图8∼10), 了解高温下纤维编织网、环氧树脂及基体混凝土的形态。 1. 环氧树脂在200 °C 高温作用90 min 时劣化严重, 造成纤维网与基体之间的界面黏结破坏, 这是导致试件破坏的主要原因; 2. 在常温或120 °C 作用下, 掺加聚丙烯(PP)纤维可以较大幅度地提高TRC 构件的承载能力; 但在200 °C、持续时间较长的高温作用下, PP 纤维的掺入对试件的承载力几乎没有影响。
1 September 2021 in Cement and Concrete Composites